Point Hook-Up, Refer to -5 & Figure | Land Pride 322-215M instruction

Land Pride

Section 1: Assembly & Set-up

25764

Roller Scraper Assembly

Figure 1-4

3-Point Hook-Up

Refer to Figure 1-5 & Figure 1-6:

!DANGER

Crushing Hazard between tractor and implement. Do not allow anyone to stand between tractor and implement while backing-up to an implement. Do not operate hydraulic 3-point lift controls while someone is directly behind the tractor or near the Seed Bed Roller.

!DANGER

Engage parking brake, shut off tractor and remove key before dismounting from the tractor.

!WARNING

See Figure 3-5 on page 15. Chock front and back of roller when using support stand to prevent unit from rolling and causing property damage and/or bodily injury.

A3-Point Category I hitch is required. The lower 3-Point arms of the 3-Point hitch must be stabilized to prevent side-to-side movement. Most tractors have sway blocks or adjustable chains for this purpose.

1.Slowly back tractor up to the Seed Bed Roller while using the tractor’s 3-point hydraulic control to align the lower lift arm hitch holes with the clevis lug holes on the Seed Bed Roller.

2.Engage tractor park brake, shut tractor engine off and remove key before dismounting from tractor.

3.With lower lift arm hitch holes aligned with clevis lug holes, insert hitch pins (#1) through clevis and lower arm holes. Secure hitch pins with linchpins (#6).

4.Align top center link hitch hole with the upper hitch holes and insert 3/4" bolt (#4). Secure bolt with flange lock nut (#5). Draw nut up snug.

5.Ensure lower hitch arms are blocked to prevent excessive side movement.

6.Return to the tractor, start engine and slowly operate 3-point controls to lift lower arms up just enough to raise support stand (#3) off the ground.

7.Engage tractor park brake, shut tractor engine off and remove key before dismounting from tractor.

8.Remove support stand (#3), turn it over and reattach it as shown in Figure 1-6with wire snap lock pin (#7). (Remember: Small notches in stand are mounted towards the frame tube.)

9.Operate 3-point controls up and down to check for clearance between the Seed Bed Roller and tractor. Move or remove tractor drawbar if it interferes with the Seed Bed Roller.

10.Manually adjust one of the two Lower lift arms up or down to level the Seed Bed Roller from left to right. Manually adjust the length of the top center link to level the Seed Bed Roller from front to rear.

11.When using a Quick Hitch, attach center hook to

1 1/4" spacer (#2) and lower hooks to hitch pins (#1).

23998
Tractor 3-Point Hitch
	Figure 1-5
Top Center Link Hole
Alignment Position
	Lower Lift Arm Hole
25781	Alignment Positions
25781

Land Pride 322-215M manual Point Hook-Up, Refer to -5 & Figure

Table of Contents

3-Point Hook-Up

Refer to Figure 1-5 & Figure 1-6: