Intel GS-SR168 manual FAN Duct Removal and Installation

Page 17

Hardware Installation Process

Step 3-7: FAN Duct Removal and Installation

Step 1 Pull up the screw-holder and lossen the thumbscrews. Lift up to remove the fan duct.

Step 2 For FAN Duct Installation, place the fan duct on the top of heat sinks. Fasten the screws to the locked position and push down the screw-holders.

Step 1

Step 2

1 7

Image 17

Contents System Installation Guide Table of Content Security Server Precaution for Product with Laser Devices Safety, Care and Regulatory InformationImportant safety information FCC part 68 applicable to products fitted with USA modems Federal Communications Commission FCC StatementCanadian Department of Communications Compliance Statement Page Introduction Contents PackagesProcessor Supported Features SummarySuper I/O System Overview Step System Hardware InstallationChassis Removal and Installation Pin1 indicator CPU InstallationMemory Installation Heat Sink InstallationPCI Expansion Card Installation Hard Disk Drive Installation FAN Duct Removal and Installation Front View of GS-SR168 Appearance of GS-SR168Rear View of GS-SR168 Hg f e Back Plane Borad Layout IntroductionNMI Switch and LED Indicators IntroductionName Color Condition Description LAN LED DescriptionConnector Icon Description GA-9IVDPL Motherboard Layout Motherboard Layout & Jumper SettingClrcmos Clear Cmos Function Jumper SettingControlkeys Bios SetupBoot Status Page Setup Menu / Option Page Setup MenuMainMenu MainSystem Date System TimeBit I/O SystemInformation About This Section Advanced AdvancedOnboard VGA Control PCI ConfigurationOnboard LAN Control Option ROM ScanLegacy USB Support Advanced Chipset ControlUSB Controller PCI-E portA Device Force Compliance Mode4GB PCI HoleGranularity Wake On LANSet Max Ext Cpuid = Advanced Processor OptionHyper Threading Technology Serial Port a Peripheral ConfigurationFloppy disk controller Serial Port BFloppy Check Parallel ATANativeModeOperation SATARAIDEnableSerial ATA Extended MemoryTesting Reset ConfigurationDataClk Gen Spread Spectrum System After AC BackHardware Monitor CPU 1&2/Backboard 1/2/3 TemperatureAbout This Section Security Set Supervisor PasswordPassword on boot Set User PasswordConsole Redirection ServerBaud Rate Com PortAddressConsole Type FlowControlHaltOn Memory RAS Feature ControlClear Mem. ECC Error Info Boot Device Priority About This Section BootAbout This Section Exit ExitExit Discarding Changes Load SettupDefaultExit Saving Changes Save Changes Discard ChangesAcronyms AppendixIoapic