Intel GS-SR168 manual Reset ConfigurationData, Clk Gen Spread Spectrum, System After AC Back

Page 39

BIOS Setup

Reset ConfigurationData

Yes

Clear the Extended System Configuration Data (ESCD) area.

No

Disable this function. (default value)

Clk Gen Spread Spectrum

Enabled

Enable ClkGen Spread Spectrum.

Disabled

Disabled this function. (Default value)

System After AC Back

Set the mode od operation if an AC/Power loss occurs.

Power On

Power on system without pressing power button.

Stay Off

Keep the power off until the power button is pressed.

Pre- State

Set system to the last sate when AC power is removed. Do not power on

 

system when AC power is back. (Default value)

Extended MemoryTesting

Determine which type of tests will be performed extended memory. (above 1M)

Enabled

Enable Extended Memory Testing. (Default value)

Disabled

Disable this function.

Network Server

Enabled

System will be secured at boot to prevent tampering during network

 

operation. (Default value)

Disabled

Disable this function.

3 9

Image 39
Contents System Installation Guide Table of Content Security Server Safety, Care and Regulatory Information Important safety informationPrecaution for Product with Laser Devices FCC part 68 applicable to products fitted with USA modems Federal Communications Commission FCC StatementCanadian Department of Communications Compliance Statement Page Introduction Contents PackagesProcessor Supported Features SummarySuper I/O System Overview System Hardware Installation Chassis Removal and InstallationStep Pin1 indicator CPU InstallationMemory Installation Heat Sink InstallationPCI Expansion Card Installation Hard Disk Drive Installation FAN Duct Removal and Installation Front View of GS-SR168 Appearance of GS-SR168Rear View of GS-SR168 Hg f e Back Plane Borad Layout IntroductionNMI Switch and LED Indicators IntroductionName Color Condition Description LAN LED DescriptionConnector Icon Description GA-9IVDPL Motherboard Layout Motherboard Layout & Jumper SettingClrcmos Clear Cmos Function Jumper SettingControlkeys Bios SetupMain Status Page Setup Menu / Option Page Setup MenuBoot MainMenuSystem Date System TimeBit I/O SystemInformation About This Section Advanced AdvancedOption ROM Scan PCI ConfigurationOnboard VGA Control Onboard LAN ControlAdvanced Chipset Control USB ControllerLegacy USB Support Wake On LAN Force Compliance ModePCI-E portA Device 4GB PCI HoleGranularityAdvanced Processor Option Hyper Threading TechnologySet Max Ext Cpuid = Serial Port a Peripheral ConfigurationParallel ATA Serial Port BFloppy disk controller Floppy CheckSATARAIDEnable Serial ATANativeModeOperation System After AC Back Reset ConfigurationDataExtended MemoryTesting Clk Gen Spread SpectrumHardware Monitor CPU 1&2/Backboard 1/2/3 TemperatureAbout This Section Security Set Supervisor PasswordPassword on boot Set User PasswordConsole Redirection ServerFlowControl Com PortAddressBaud Rate Console TypeMemory RAS Feature Control Clear Mem. ECC Error InfoHaltOn Boot Device Priority About This Section BootAbout This Section Exit ExitLoad SettupDefault Exit Saving ChangesExit Discarding Changes Save Changes Discard ChangesAcronyms AppendixIoapic