Intel GS-SR168 manual Serial Port B, Floppy disk controller, Floppy Check, Parallel ATA

Page 37

BIOS Setup

Serial Port B

This allows users to configure serial prot B by using this option.

Disabled

Disable the configuration.

Enabled

Enable the configuration (Default value)

Base I/O Address/IRQ

3F8/IRQ4

Set IO address to 3F8.

2F8/IRQ3

Set IO address to 2F8. (Default value)

3E8/IRQ4

Set IO address to 3E8.

2E8/IRQ3

Set IO address to 2E8.

Floppy disk controller

Enabled

Enable the floppy disk controller. (Default value)

Disabled

Disable the device.

Floppy Check

Enabled

Enable the device to verify floppy typer when system boot.

 

(Default value)

Disabled

Disable the this function.

Parallel ATA

Disabled

Disable the device.

Both

Select both Channel 0 and Channel 1 as Parallel ATA.

 

(Default value)

Channel 0

Select both Channel 0 as Parallel ATA.

Channel1

Select both Channel 1 as Parallel ATA.

3 7

Image 37
Contents System Installation Guide Table of Content Security Server Important safety information Safety, Care and Regulatory InformationPrecaution for Product with Laser Devices FCC part 68 applicable to products fitted with USA modems Federal Communications Commission FCC StatementCanadian Department of Communications Compliance Statement Page Introduction Contents PackagesProcessor Supported Features SummarySuper I/O System Overview Chassis Removal and Installation System Hardware InstallationStep Pin1 indicator CPU InstallationMemory Installation Heat Sink InstallationPCI Expansion Card Installation Hard Disk Drive Installation FAN Duct Removal and Installation Front View of GS-SR168 Appearance of GS-SR168Rear View of GS-SR168 Hg f e Back Plane Borad Layout IntroductionNMI Switch and LED Indicators IntroductionName Color Condition Description LAN LED DescriptionConnector Icon Description GA-9IVDPL Motherboard Layout Motherboard Layout & Jumper SettingClrcmos Clear Cmos Function Jumper SettingControlkeys Bios SetupBoot Status Page Setup Menu / Option Page Setup MenuMainMenu MainSystem Date System TimeBit I/O SystemInformation About This Section Advanced AdvancedOnboard VGA Control PCI ConfigurationOnboard LAN Control Option ROM ScanUSB Controller Advanced Chipset ControlLegacy USB Support PCI-E portA Device Force Compliance Mode4GB PCI HoleGranularity Wake On LANHyper Threading Technology Advanced Processor OptionSet Max Ext Cpuid = Serial Port a Peripheral ConfigurationFloppy disk controller Serial Port BFloppy Check Parallel ATASerial ATA SATARAIDEnableNativeModeOperation Extended MemoryTesting Reset ConfigurationDataClk Gen Spread Spectrum System After AC BackHardware Monitor CPU 1&2/Backboard 1/2/3 TemperatureAbout This Section Security Set Supervisor PasswordPassword on boot Set User PasswordConsole Redirection ServerBaud Rate Com PortAddressConsole Type FlowControlClear Mem. ECC Error Info Memory RAS Feature ControlHaltOn Boot Device Priority About This Section BootAbout This Section Exit ExitExit Saving Changes Load SettupDefaultExit Discarding Changes Save Changes Discard ChangesAcronyms AppendixIoapic