Intel GS-SR168 manual Peripheral Configuration, Serial Port a

Page 36

GS-SR168 Rack Mount Server

Peripheral Configuration

	PhoenixBIOS Setup Utility
Peripheral Configuration		Item Specific Help
Serial Port A	[Enabled]
Base I/O address/IRQ	[3F8/IRQ4]
Serial Port B	[Enabled]
Base I/O address/IRQ	[2F8/IRQ3]
Floppy disk connector	[Enabled]
Floppy Check	[Enabled]
Parallel ATA	[Both]
Serial ATA	[Enabled]
Native Mode Operation	[Auto]
SATA RAID Enable	[Disabled]

F1: Help	KL: Select Item	+ -: Change Values	F5: Setup Defaults
Esc: Exit	IJ: Select Menu	Enter: Select Sub-Menu F10: Save&Exit

Figure 2-4: Peripheral Configuration

Serial Port A

This allows users to configure serial prot A by using this option.

Disabled	Disable the configuration.
Enabled	Enable the configuration (Default value)
Base I/O Address/IRQ
3F8/IRQ4	Set IO address to 3F8.	(Default value)
2F8/IRQ3	Set IO address to 2F8.
3E8/IRQ4	Set IO address to 3E8.
2E8/IRQ3	Set IO address to 2E8.

3 6

Image 36

Contents System Installation Guide Table of Content Security Server Safety, Care and Regulatory Information Important safety informationPrecaution for Product with Laser Devices Federal Communications Commission FCC Statement FCC part 68 applicable to products fitted with USA modemsCanadian Department of Communications Compliance Statement Page Contents Packages IntroductionFeatures Summary Processor SupportedSuper I/O System Overview System Hardware Installation Chassis Removal and InstallationStep CPU Installation Pin1 indicatorHeat Sink Installation Memory InstallationPCI Expansion Card Installation Hard Disk Drive Installation FAN Duct Removal and Installation Appearance of GS-SR168 Front View of GS-SR168Rear View of GS-SR168 Back Plane Borad Layout Introduction Hg f eSwitch and LED Indicators Introduction NMILAN LED Description Name Color Condition DescriptionConnector Icon Description Motherboard Layout & Jumper Setting GA-9IVDPL Motherboard LayoutJumper Setting Clrcmos Clear Cmos FunctionBios Setup ControlkeysStatus Page Setup Menu / Option Page Setup Menu BootMainMenu MainSystem Time System DateBit I/O SystemInformation Advanced About This Section AdvancedPCI Configuration Onboard VGA ControlOnboard LAN Control Option ROM ScanAdvanced Chipset Control USB ControllerLegacy USB Support Force Compliance Mode PCI-E portA Device4GB PCI HoleGranularity Wake On LANAdvanced Processor Option Hyper Threading TechnologySet Max Ext Cpuid = Peripheral Configuration Serial Port aSerial Port B Floppy disk controllerFloppy Check Parallel ATASATARAIDEnable Serial ATANativeModeOperation Reset ConfigurationData Extended MemoryTestingClk Gen Spread Spectrum System After AC BackCPU 1&2/Backboard 1/2/3 Temperature Hardware MonitorSet Supervisor Password About This Section SecuritySet User Password Password on bootServer Console RedirectionCom PortAddress Baud RateConsole Type FlowControlMemory RAS Feature Control Clear Mem. ECC Error InfoHaltOn About This Section Boot Boot Device PriorityExit About This Section ExitLoad SettupDefault Exit Saving ChangesExit Discarding Changes Discard Changes Save ChangesAppendix AcronymsIoapic