ViewSonic PJ510 manual Auto Menu, Adjust, Power OFF, Search

AUTO Menu

With the AUTO menu, the items shown in the Table below can be performed. Perform each operation in accordance with the instructions in the table below.

Item		Description
ADJUST	Automatically Adjust the Picture:
	Pressing the (X) or the ENTER button performs this function
	At a RGB input:
	•	V POSITION, H POSITION, H PHASE and HSIZE are automatically adjusted. Please use this
		function with the maximum window size.
	At a VIDEO input or S-VIDEO input:
	•	This function performs only when the AUTO is selected under the VIDEO item of the INPUT menu.
		For a COMPONENT VIDEO input, although this function is ineffective, the signal type is identified
		automatically even if the AUTO is not selected. For HDTV signals, refer to the HDTV item below.
	•	This function automatically selects the optimum mode for the input signal. However, it may not
		work well at a PAL60 signal and some other signals. If the picture becomes unstable (ex. irregular
		picture, color lack), please use the function of VIDEO of the INPUT menu.
	•	The operation of this function requires approximately 10 seconds.
POWER OFF	Set the Automatically Power Off Timer:
	Long (Max. 99 minutes.) (S) Q (T) Short (Min. 0 minute =DISABLE)
	•	This function performs only when the time is set to 1 to 99.
	•	When the set time passes without a valid signal (there is no signal, or the signal is out of
		specifications), the projector lamp automatically goes off, and the POWER indicator begins
		blinking. Please refer to the section “Turning OFF The Projector” of “Power ON/OFF” about the
		turning off.
SEARCH	Automatically Signal Search:
	TURN ON (S) Q (T) TURN OFF
	•	If the TURN ON is selected under this item when no signal input is detected, the projector begins
		searching for an input signal. When an input signal is detected the projector will cease searching
		and the picture will appear.
	•	The priority of a search is as follows:
	•	If the projector is unstable to find an input signal at any of its ports, it will return to the state it was
		in prior to the search.
RESET	Reset the AUTO Menu Items:
	Selecting the EXECUTE performs this function.
	EXECUTE (S)  CANCEL
	•	The items of the AUTO menu are collectively returned to the initial setting. Note that the item
		ADJUST is not reset.

27 ViewSonic PJ510