Intel XP-P41533E user manual Installation of a Pentium 4 CPU and Fan Sink

Page 10

English

2.1.Installation of a Pentium 4 CPU and Fan Sink

1

Note the small gold colored triangle on one corner of the CPU. Place the triangle in the corner closest to the metal lever and gently insert the CPU into its position.

2

When the CPU is inserted into its position, gently press the metal lever downwards until a click is heard. Then add an even layer of heat sink paste between the CPU and fan sink for heat dissipation.

3

Position and attach the clips on one end of the fan sink firmly atop the CPU. Please do the same for the clips on the other end of the fan sink.

4

Connect the 3-pin cooler power connector to the CPU Fan connector located on the motherboard.

2.2.Installation of Memory

1.Before installing or removing memory, please make sure that the computer power is turned off to prevent hardware damage.

2.Please make sure that the memory used is supported by the motherboard.

3.Memory modules have a foolproof insertion design. The memory can be in stalled only when facing the correct position. If you cannot insert the module, please switch directions.

4.It is recommended that memory of similar capacity, specifications and brand be used.

The motherboard supports DIMM memory modules, whereby BIOS will automatically detect memory capacity and specifications. Memory modules are designed so that they can be inserted only in one direction.

10

Image 10
Contents XP-P4I533E Copyright Declaration Legal Disclaimer Terms of UseContents Motherboard Layout Production Introduction FDD Floppy Disk Drive Connector IDE1 / IDE2 IDE1 and IDE2 ConnectorATX ATX Power Connector CPUFANCPUFanPowerConnectorSYSFANSystemFanPowerConnectorATX12V +12V Power Connector Fpanel Front Panel Control ConnectorFUSB1 Front USB Connector Faudio Front Audio ConnectorCdin Optical Drive Audio Connector Clrcmos Clear CmosHardware Installation BAT1BatteryInstallation of a Pentium 4 CPU and Fan Sink Installation of the Graphics Card English Bios Setup Setup Screen Features Bios versionE5Date mmddyy Standard Cmos FeaturesTime hhmmss Halt on Floppy 3 Mode SupportMemory Advanced Bios Features Integrated Peripherals UR2 Duplex Mode Onboard LAN Boot ROM Onboard Serial PortUart Mode Select Use IR PinsMidi Port Address Game Port AddressMidi Port IRQ Power Management Setup PnP/PCI Configuration Current VoltageV Vcore / +3.3V / +5V / +12V / +1.8V Current CPU / System TemperaturePC Health Status Current CPU / System FAN Speed RPMCPU Host Clock Control Frequency/Voltage ControlCPU Clock Ratio CPU Host Frequency MHzMemory Frequency Mhz Fixed PCI/AGP FrequencyHost/DRAM Clock Ratio PCI/AGP FrequencyMhzSet User Password Load Fail-Safe DefaultsLoad Optimized Defaults Save & Exit SetupDriver Installation