7 - Advanced operations
Event start
Connect the RELAY IN jack (mini jack) on the rear panel and event start terminal on the external device which supports the event start function.
The relay play menu (menu number 06 RELAY) should
be set to ON.
Restoring factory default settings
To restore all settings to their factory defaults:
1 Select the factory preset menu (menu number 14 F- PRE).
2 The display shows 14 flashing, then press the PITCH knob on the front panel or ENTER key on the remote control to confirm the selection.
3 The display shows - SURE - flashing to recomfirm that this operation is surely desired.
4 Press the PITCH knob on the front panel or ENTER key on the remote control to restore all settings to their default values.
The following settings are restored to default values.
≠Playback mode
≠Time display mode
≠Auto ready
≠Auto cue
≠Pitch control value
≠All menu settings
You can cancel to restore the default settings either the
stage 14
other keys except the SHIFT key and the PITCH knob
on the front panel.
External parallel control
The
devices which supports a parallel interface via the CON-
TROL I/O terminal on the rear panel.
REMOTE(PARALLEL)
81
159
Pin No. | Description | In/Out |
1 | Stop tally | Out |
2 | Skip (Back) | In |
3 | Skip (Forward) | In |
4 | No Disc tally | Out |
5 | EOM tally | Out |
6 | Search (Back) | In |
7 | Search (Forward) | In |
8 | GND |
|
9 | Play tally | Out |
10 | Pause tally | Out |
11 | Fader start/stop | In |
12 | Stop | In |
13 | Play | In |
14 | Pause | In |
15 | +5V |
|
In:
Input signals are active when low (ground) for > 30 ms.
Out:
Tally signals are open collector, with a maximum current of 50 mA.
+5V:
The maximum current supplied from this terminal is 50 mA.
24 TASCAM