Intel GA-8I915MK-GV IDE Channel 0 Master, Slave, IDE Channel 2/3 Master, Slave, Drive a / Drive B

Page 32
No floppy drive installed
5.25 inch PC-type standard drive; 360K byte capacity. 5.25 inch AT-typehigh-density drive; 1.2M byte capacity (3.5 inch when 3 Mode is Enabled).
3.5 inch double-sided drive; 720K byte capacity
3.5 inch double-sided drive; 1.44M byte capacity.
3.5 inch double-sided drive; 2.88M byte capacity.

English

IDE Channel 0 Master, Slave

IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection. IDE Device Setup. You can use one of three methods:

Auto

Allows BIOS to automatically detect IDE devices during POST(default)

None

Select this if no IDE devices are used and the system will skip the automatic

 

detection step and allow for faster system start up.

Manual

User can manually input the correct settings

Access Mode

Use this to set the access mode for the hard drive. The four options are:

 

CHS/LBA/Large/Auto(default:Auto)

IDE Channel 2/3 Master, Slave

IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection. Extended IDE Drive SATA devices setup. You can use one of two methods:

Auto

Allows BIOS to automatically detect SATA IDE devices during POST.

 

(Default value)

None

Select this if no SATA IDE devices are used and the system will skip the

 

automatic detection step and allow for faster system start up.

Access Mode

Use this to set the access mode for the hard drive. The two options are:

 

Large/Auto(default:Auto)

Capacity

Capacity of currently installed hard disk.

Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information.

Cylinder

Number of cylinders

Head

Number of heads

Precomp

Write precomp

Landing Zone

Landing zone

Sector

Number of sectors

Drive A / Drive B

The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.

None

360K, 5.25" 1.2M, 5.25"

720K, 3.5"

1.44M, 3.5" 2.88M, 3.5"

Floppy 3 Mode Support (for Japan Area)

Disabled

Normal Floppy Drive. (Default value)

Drive A

Drive A is 3

mode Floppy Drive.

Drive B

Drive B is 3

mode Floppy Drive.

Both

Drive A & B are 3 mode Floppy Drives.

GA-8I915MK-GV Motherboard

- 32 -

Image 32
Contents GA-8I915MK-GV Motherboard Copyright Product Manual ClassificationTable of Contents Install Drivers GA-8I915MK-GV Motherboard Layout 8I915MK-GVBlock Diagram Page Considerations Prior to Installation Installation NoticesInstances of Non-Warranty Preparing Your ComputerFeature Summary CPUUse of licensed Award Bios Installation of the CPU and Heatsink Installation of the CPUInstallation of the Heatsink Installation of Memory Installation of Expansion Cards Dual Channel DDRI/O Back Panel Introduction Connectors Introduction EnglishATX12V/ATX Power Connector Cpufan / Sysfan Cooler Fan Power Connector FDD FDD ConnectorIDE1 IDE Connector SATA0/SATA1 Serial ATA ConnectorFpanel Front Panel Connector Faudio Front Audio Panel Connector PwrledCdin CD in Connector Auxin AUX In ConnectorSpdifio Spdif In/ Out SurcenFUSB1 / FUSB2 Front USB Connectors Comb Comb ConnectorCI Chassis Intrusion, Case Open Clrcmos Clear CmosBAT Battery English Status Page Setup Menu / Option Page Setup Menu Main MenuMain Menu For example Bios Ver. F1 Standard Cmos Features Floppy 3 Mode Support for Japan Area IDE Channel 0 Master, SlaveIDE Channel 2/3 Master, Slave Drive a / Drive BHalt on MemoryBase Memory Extended MemoryFirst / Second / Third Boot Device Advanced Bios FeaturesHard Disk Boot Priority Password Check CPU Hyper-ThreadingLimit Cpuid Max. to No-Execute Memory Protect NoteIntegrated Peripherals SPPOnboard LAN Boot ROM USB 2.0 ControllerUSB Keyboard Support USB Mouse SupportECP Mode Use DMA Power Management SetupParallel Port Mode Power On by Ring Resume by AlarmPower On By Mouse Power On By KeyboardPnP/PCI Configurations PCI 1 IRQ AssignmentPC Health Status CPU Smart FAN Mode Frequency / Voltage ControlCPU Smart FAN Control CPU Clock RatioCPU Host Clock Control CPU Host Frequency MhzPCI-E Frequency to CPU Memory Frequency ForNormal CPU Vcore FSB OverVoltage ControlCPU Voltage Control Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingEnglish Install Drivers Install Chipset DriversSoftware Applications Driver CD InformationHardware Information Contact UsEnglish Unique Software Utilities EasyTune 5 Introduction User Interface OverviewHow to use the Xpress Recovery Xpress Recovery IntroductionWhat is Xpress Recovery ? F9 For Xpress Recovery Remove Backup Image  Remove backup image. Are you sure? Y/N Exit and RestartBefore You Begin Flash Bios Method IntroductionMethod 1 Q-FlashTMUtility Exploring the Q-FlashTM / Dual Bios utility screen Task menu for Dual Bios utilityEntering the Q-FlashTMutility Task menu for Q-Flash utilityUsing the Q-FlashTMutility StepsYou can repeat to Part Two Exploring the Q-FlashTMutility screen FlashTMutility barCongratulation!! You have updated Bios successfully Method 2 @BIOSTM Utility Methods and stepsEnglish Channel Audio Setup 5 2 / 4 / 6 Channel Audio Function IntroductionChannel Analog Audio Output Mode Basic 6 Channel Analog Audio Output Mode English Basic 6 Channel Analog Audio Output Mode Notes Spdif Output Device Optional Device Troubleshooting AMI Bios Beep CodesEnglish English English English English Contact Us Taiwan HeadquartersChina Shanghai