Intel LH500 user manual PCI-X Slot 1 Jumper Setting

Page 26

2.4.3 PCI-X Slot 1 Jumper Setting:

Header CN8 controls PCI-X Slot 1 setting. When CN8 is open, slot 1 is set to 133MHz. When CN8 is on, slot 1 is set to 100MHz. The frequencies describe here are maximum operating frequencies. If PCI-X channel is shared with other devices, then maximum operating frequency cannot be achieved. Refer to the following diagram for the location of CN8.

26

Image 26

Contents LH500 Arima Computer Corp Table of Contents IDE Channel sub-menu Boot Feature sub-menu Legal Disclaimer Technical Support Safety Instruction Congratulations UnpackingQuick Installation Guide CN46Features Highlight Motherboard Specification Bios Motherboard Layout major components Hardware Monitor Hardware Installation Mounting the motherboardInstalling the processor Page Page Page Heatsink not included in the package Installing the memory Dimm combinationPage Installing Dimm modules Page Jumpers Configuration Clear Cmos headerEnable onboard VGA header PCI-X Slot 1 Jumper Setting PCI-X Slot 2 Jumper PCI-X Slot 5 Jumper LAN 82546GB Power Supply ATX 24-pin power connectorPage ATX 8-pin power connector Cables & Connectors Floppy disk drive connectorPage IDE connectors Front Panel Connectors Computer without turning on/off your power switch Rear Panel I/O ports Blink Back Panel LAN LEDOFF Front Panel LAN LED Connector System Speaker Connector Front USB Connector Page Front Panel Serial Port Connector Bios Setup Using Setup KEY FunctionTroubleshooting Main Menu MM/DD/YYYYIDE Channel sub-menu CD-ROMFpio 3/ DMA Fpio 4/ DMA Boot Feature sub-menu Advanced Menu DOSPage Advanced Chipset Sub Menu Advanced Chipset Control Sub Menu looks like the followingPCI Express Device Control Sub Menu Advanced Processor Options Sub Menu 4 I/O Device Configuration Sub Menu IRQVT-UTF8 Console Redirection Sub MenuPC-ANSI XON/XOFF CTS/RTSIpmi Sub Menu Ipmi Sub Menu looks like the followingYyyy MM DD MM DD YyyyDD MM Yyyy Security Menu SecurityPower Menu PowerThis state but remain in a lower Boot Menu BootSaving Changes Load Setup DefaultsExit Menu Exit Discarding ChangesDiscard Changes Save ChangesAbout the Boot Utilities Using Phoenix QuietBootPage Phoenix MultiBoot Atapi CD-ROMPHLASH16 Bios Flash Upgrade UtilityExecuting Phoenix Phlash BBLAppendix I Glossary Page Page Page Page Appendix II Block Diagram Page Appendix III FAQ