Intel LH500 user manual

Page 74

PCI-to-PCI bridge: allows you to connect multiple PCI devices onto one PCI slot.

PnP (Plug-n-Play):a design standard that has become ascendant in the industry. Plug-n- Play devices require little set-up to use. Devices and operating systems that are not Plug- n-Play require you to reconfigure your system each time you add or change any part of your hardware.

RAID (Redundant Array of Independent Disks): a way for the same data to be stored in different places on many hard drives. By using this method, the data is stored redundantly and multiple hard drives will appear as a single drive to the operating system. RAID level 0 is known as striping, where data is striped (or overlapped) across multiple hard drives, but offers no fault-tolerance. RAID level 1 is known as mirroring, which stores the data within at least two hard drives, but does not stripe. RAID level 1 also allows for faster access time and fault-tolerance, since either hard drive can be read at the same time. RAID level 0+1 is both striping and mirroring, providing fault-tolerance, striping, and faster access all at the same time.

SDRAM (Synchronous Dynamic RAM): called as such because it can keep two sets of memory addresses open simultaneously. By transferring data alternately from one set of addresses and then the other, SDRAM cuts down on the delays associated with non- synchronous RAM, which must close one address bank before opening the next.

Serial port: called as such because it transmits the eight bits of a byte of data along one wire, and receives data on another single wire (that is, the data is transmitted in serial form, one bit after another).

Sleep/Suspend mode: in this mode, all devices except the CPU shut down.

SRAM (Static RAM): unlike DRAM, this type of RAM does not need to be refreshed in order to prevent data loss. Thus, it is faster and more expensive.

SMBIOS: The system management specification addresses how motherboard and system vendors present management information about their products in a standard format by extending the BIOS interface on Intel architecture systems.

Standby mode: in this mode, the video and hard drives shut down; all other devices continue to operate normally.

UltraDMA-33/66/100:a fast version of the old DMA channel. UltraDMA is also called UltraATA. Without a proper UltraDMA controller, your system cannot take advantage of higher data transfer rates of the new UltraDMA/UltraATA hard drives.

USB (Universal Serial Bus): a versatile port. This one port type can function as a serial, parallel, mouse, keyboard or joystick port. It is fast enough to support video transfer, and is capable of supporting up to 127 daisy-chained peripheral devices.

74

Image 74
Contents LH500 Arima Computer Corp Table of Contents IDE Channel sub-menu Boot Feature sub-menu Legal Disclaimer Technical Support Safety Instruction Congratulations UnpackingQuick Installation Guide CN46Features Highlight Motherboard Specification Bios Motherboard Layout major components Hardware Monitor Hardware Installation Mounting the motherboardInstalling the processor Page Page Page Heatsink not included in the package Installing the memory Dimm combinationPage Installing Dimm modules Page Jumpers Configuration Clear Cmos headerEnable onboard VGA header PCI-X Slot 1 Jumper Setting PCI-X Slot 2 Jumper PCI-X Slot 5 Jumper LAN 82546GB Power Supply ATX 24-pin power connectorPage ATX 8-pin power connector Cables & Connectors Floppy disk drive connectorPage IDE connectors Front Panel Connectors Computer without turning on/off your power switch Rear Panel I/O ports Blink Back Panel LAN LEDOFF Front Panel LAN LED Connector System Speaker Connector Front USB Connector Page Front Panel Serial Port Connector Bios Setup Using Setup KEY FunctionTroubleshooting Main Menu MM/DD/YYYYIDE Channel sub-menu CD-ROMFpio 3/ DMA Fpio 4/ DMA Boot Feature sub-menu Advanced Menu DOSPage Advanced Chipset Sub Menu Advanced Chipset Control Sub Menu looks like the followingPCI Express Device Control Sub Menu Advanced Processor Options Sub Menu 4 I/O Device Configuration Sub Menu IRQVT-UTF8 Console Redirection Sub MenuPC-ANSI XON/XOFF CTS/RTSIpmi Sub Menu Ipmi Sub Menu looks like the followingYyyy MM DD MM DD YyyyDD MM Yyyy Security Menu SecurityPower Menu PowerThis state but remain in a lower Boot Menu BootSaving Changes Load Setup DefaultsExit Menu Exit Discarding ChangesDiscard Changes Save ChangesAbout the Boot Utilities Using Phoenix QuietBootPage Phoenix MultiBoot Atapi CD-ROMPHLASH16 Bios Flash Upgrade UtilityExecuting Phoenix Phlash BBLAppendix I Glossary Page Page Page Page Appendix II Block Diagram Page Appendix III FAQ