Note: If this LED is off, it does not mean that there is no electrical power in the server. The LED might be burned out. To remove all electrical power from the server, you must disconnect the power cord from the electrical outlet.
Reset button: Press this button to reset the server and run the
Hard disk drive activity LED: When this LED is flashing, it indicates that a hard disk drive is in use.
Locator LED: This LED can be lit remotely by the system administrator to aid in visually locating the server.
Rear view
The following illustration shows the LEDs on the rear of the server.
1 | Ethernet 1 activity LED | 3 | Ethernet 2 activity LED |
2 | Ethernet 1 link LED | 4 | Ethernet 2 link LED |
Ethernet activity LED: This LED is on each Ethernet connector. When this LED is lit, it indicates that there is activity between the server and the network.
Ethernet link LED: This LED is on each Ethernet connector. When this LED is lit, it indicates that the Ethernet controller is connected to the network.
The following illustration shows the connectors on the rear of the server.
1 | 5 | Ethernet 1 connector | |
2 | 6 | Ethernet 2 connector | |
3 | USB 3 connector | 7 | Video connector |
4 | USB 4 connector | 8 | Serial connector |