vDevices and I/O Ports
Select this choice to view or change assignments for devices and input/output (I/O) ports, to configure remote console redirection, to enable or disable integrated Ethernet controllers and all standard ports (such as serial and USB), and to view the system MAC addresses. If you disable a device, it cannot be configured, and the operating system will not be able to detect it (this is equivalent to disconnecting the device). If you disable the integrated Ethernet controllers and no Ethernet adapter is installed, the server will have no Ethernet capability.
For a SATA model, you can also select this choice to view or change the interface mode for a SATA port. To view or change the mode, select Programming Interface for a SATA Port.
–Native mode: Standard PCI resource steering is used.
–Combined mode: Native mode plus legacy mode is used. In legacy mode, standard IDE I/O and IRQ resources (IRQ 14 and 15) are assigned.
This choice is on the full Configuration/Setup Utility menu only.
vDate and Time
Select this choice to set the date and time in the server, in
This choice is on the full Configuration/Setup Utility menu only.
vSystem Security
Select this choice to set passwords. For more information about passwords, see “Passwords” on page 42.
This choice is on the full Configuration/Setup Utility menu only.
–Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended to be used by a system administrator; it limits access to the full Configuration/Setup Utility menu. If an administrator password is set, the full Configuration/Setup Utility menu is available only if you type the administrator password at the password prompt. For more information, see “Administrator password” on page 43.
–Power-on Password
Select this choice to set or change a
vStartup Options
Select this choice to view or change the startup options, such as the startup sequence, the keyboard NumLock state, the option ROM execution priorities, whether displayless operation is enabled, whether to restart on POST/BIOS error, and other startup considerations. You can also select this choice to enable or disable hard disk drive
Select the option ROM
The startup sequence specifies the order in which the server checks devices to find a boot record. The server starts from the first boot record that it finds. For
Chapter 3. Configuring the server 39