Lenovo 8342, 8288, 8329, 8297, 8380, 8326 manual Modem safety information, Laser compliance statement

Page 13

Dispose of the battery as required by local ordinances or regulations.

Modem safety information

Caution

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

To reduce the risk of fire, electrical shock, or injury when using telephone equipment, always follow basic safety precautions, such as:

vNever install telephone wiring during a lightning storm.

vNever install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

vNever touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

vUse caution when installing or modifying telephone lines.

vAvoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

vDo not use the telephone to report a gas leak in the vicinity of the leak.

Laser compliance statement

Some personal computer models are equipped from the factory with a CD-ROM drive or a DVD-ROM drive. CD-ROM drives and DVD-ROM drives are also sold separately as options. CD-ROM drives and DVD-ROM drives are laser products. These drives are certified in the U.S. to conform to the requirements of the Department of Health and Human Services 21 Code of Federal Regulations (DHHS 21 CFR) Subchapter J for Class 1 laser products. Elsewhere, these drives are certified to conform to the requirements of the International Electrotechnical Commission (IEC) 825 and CENELEC EN 60 825 for Class 1 laser products.

When a CD-ROM drive or a DVD-ROM drive is installed, note the following handling instructions.

Caution

Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

Removing the covers of the CD-ROM drive or DVD-ROM drive could result in exposure to hazardous laser radiation. There are no serviceable parts inside the CD-ROM drive or DVD-ROM drive. Do not remove the drive covers.

Some CD-ROM drives and DVD-ROM drives contain an embedded Class 3A or Class 3B laser diode. Note the following statement.

Danger

Laser radiation when open. Do not stare into the beam, do not view directly with optical instruments, and avoid direct exposure to the beam.

Important safety information

xi

Image 13
Contents User Guide Types 8288, 8297 Types 8329, 8342 Page User Guide Types 8288, 8297 Types 8329, 8342 Page Contents Iv User Guide Conditions that require immediate action Important safety informationService General safety guidelinesPower cords and power adapters Plugs and outlets Extension cords and related devicesBatteries Heat and product ventilation CD and DVD drive safetyLithium battery notice Additional safety informationTo connect To disconnect Laser compliance statement Modem safety informationPower supply statement Information resources OverviewXiv User Guide Features Installing optionsVideo subsystem Operating systems preinstalled varies by model type Specifications Tools required Available optionsHandling static-sensitive devices Installing external optionsLocating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector DescriptionRemoving the cover Locating components Identifying parts on the system board What to do next Installing memoryInstalling adapters What to do next Drive specifications Installing internal drivesInstalling options Installing a drive in bay 1 or bay Installing options Connecting the first optical drive Connecting drivesInstalling security features Connecting a serial ATA hard disk driveIntegrated cable lock Changing the battery Password protectionPadlock Erasing a lost or forgotten password clearing Cmos Replacing the cover and connecting the cables User Guide Starting the Setup Utility program Using the Setup UtilityViewing and changing settings Using passwordsAdministrator Password User PasswordSetting, changing, and deleting a password Using Security Profile by DeviceSelecting a temporary startup device Selecting a startup deviceChanging the startup device sequence Exiting from the Setup Utility program Advanced settingsAppendix A. Updating system programs Updating flashing Bios from a diskette or CD-ROMSystem programs Recovering from a POST/BIOS update failure Updating flashing Bios from your operating systemCleaning an optical mouse Appendix B. Cleaning the mouseCleaning a mouse with a ball User Guide Basic AT commands Appendix C. Manual modem commandsSet Pulse dial as default Low speaker volumeSet Tone Dial as default Internal speaker on until carrier detectedExtended AT commands MNP/V.42/V.42bis/V.44 commands Fax Class 2 commands Fax Class 1 commandsVoice commands Appendix C. Manual modem commands User Guide Appendix D. Notices Trademarks Television output noticeIndex Password lost or forgotten Page Part Number 41D4435