Lenovo 8326, 8288, 8342, 8329, 8297, 8380 manual Installing options

Page 35

4.Remove the plastic panel in the bezel for bay 2 by squeezing the plastic tabs that secure the panel on the inside of the bezel.

5.If you are installing any type of drive other than a serial ATA hard disk drive, make sure the drive that you are installing is set correctly as either a master or a slave device.

Note: A serial ATA hard disk drive does not need to be set as either a master or a slave device.

vIf it is the first optical drive, set it as a master device.

vIf it is an additional drive, set it as a slave device.

vIf it is an additional parallel ATA hard disk drive, set it as a slave device.

Refer to the documentation that comes with your drive for master/slave jumper information.

6.For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to 3.5-inch.

7.Install the drive into the bay. Align the screw holes and install the two screws to secure the drive.

8.Install the front bezel by aligning the plastic tabs on the side of the bezel with the corresponding holes in the chassis until the bezel snaps into position.

9.Continue at “Connecting drives” on page 20.

Chapter 1. Installing options 19

Image 35

Contents User Guide Types 8288, 8297 Types 8329, 8342 Page User Guide Types 8288, 8297 Types 8329, 8342 Page Contents Iv User Guide Conditions that require immediate action Important safety informationService General safety guidelinesPower cords and power adapters Batteries Extension cords and related devicesPlugs and outlets Heat and product ventilation CD and DVD drive safetyTo connect To disconnect Additional safety informationLithium battery notice Laser compliance statement Modem safety informationPower supply statement Information resources OverviewXiv User Guide Features Installing optionsVideo subsystem Operating systems preinstalled varies by model type Specifications Tools required Available optionsHandling static-sensitive devices Installing external optionsLocating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector DescriptionRemoving the cover Locating components Identifying parts on the system board What to do next Installing memoryInstalling adapters What to do next Drive specifications Installing internal drivesInstalling options Installing a drive in bay 1 or bay Installing options Connecting the first optical drive Connecting drivesInstalling security features Connecting a serial ATA hard disk driveIntegrated cable lock Padlock Password protectionChanging the battery Erasing a lost or forgotten password clearing Cmos Replacing the cover and connecting the cables User Guide Using passwords Using the Setup UtilityStarting the Setup Utility program Viewing and changing settingsUsing Security Profile by Device User PasswordAdministrator Password Setting, changing, and deleting a passwordChanging the startup device sequence Selecting a startup deviceSelecting a temporary startup device Exiting from the Setup Utility program Advanced settingsSystem programs Updating flashing Bios from a diskette or CD-ROMAppendix A. Updating system programs Recovering from a POST/BIOS update failure Updating flashing Bios from your operating systemCleaning a mouse with a ball Appendix B. Cleaning the mouseCleaning an optical mouse User Guide Basic AT commands Appendix C. Manual modem commandsInternal speaker on until carrier detected Low speaker volumeSet Pulse dial as default Set Tone Dial as defaultExtended AT commands MNP/V.42/V.42bis/V.44 commands Fax Class 2 commands Fax Class 1 commandsVoice commands Appendix C. Manual modem commands User Guide Appendix D. Notices Trademarks Television output noticeIndex Password lost or forgotten Page Part Number 41D4435