Appendix F. Lenovo regulatory notice
Les périphériques d’émission sont conçus pour fonctionner avec des antennes intégrées aux Lenovo et ayant un gain maximal de moins de 3 dBi.
Le gain d’antenne maximal pour les périphériques dans les bandes de fréquence
Lorsque vous utilisez le modèles 512AN_MMW, 533AN_MMW*:
•Tout appareil destiné à la bande
•Les radars à forte puissance sont désignés comme les utilisateurs principaux
IV) Exposition des êtres humains aux champs radioélectriques (RF)
L’énergie émise par les antennes reliées aux adaptateurs sans fil respecte la limite d’exposition aux radiofréquences telle que définie par Industrie Canada dans la clause 4.2 du document
*Le réseau local sans fil (Modèle: 533AN_MMW) n’est pas utilisé sur Lenovo G550.
Electronic emission notices
Federal Communications Commission (FCC) Statement
•Model: 512AN_MMW
•Model: 512ANXMMW
•Model: 533AN_MMW*
Note: The compliance of the FCC Part 15 Subpart B for Models: 512AN_MMW, 533AN_MMW*, 512ANXMMW was proceeded by certification, thus the FCC ID: PD9LEN512ANMU, PD9533ANMU, PD9512ANXMU respectively include both compliances of Part 15 Subpart B and C/E.
* The Wireless LAN module (Model: 533AN_MMW) is not used in Lenovo G550.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
69