3.Make sure that the cables are routed correctly before reinstalling the server cover. Keep cables clear of the hinges and sides of the server chassis to avoid interference with reinstalling the server cover.
4.Position the server cover on the chassis so that the rail guides on the bottom of the server cover engage the rails on the chassis. Then, slide the cover to the front of the server until it snaps into position.
Figure 64. Reinstalling the server cover
5.Install the screws to secure the server cover.
6.Lock the server cover if you have a server cover lock. See “Integrated cable lock” on page 81 or “Padlock” on page 81.
7.Reconnect the external cables and power cords to the server. See “Front view of the server” on page 12 and “Rear view of the server” on page 13.
8.Depending on the parts you installed or replaced, you might need to confirm the updated information in the Setup Utility program. Refer to Chapter 5 “Configuring the server” on page 21.
Note: In most areas of the world, Lenovo requires the return of the defective Customer Replaceable Unit (CRU). Information about this will come with the CRU or will come a few days after the CRU arrives.
Connecting the cables
Attention: To prevent damage to equipment, connect the power cords after completing the parts replacement.
If the server cables and connector panel have