Smart Technologies (XP20-2000i-B) manual Supplied 6 15.2 cm

Page 10

3.Connect the supplied 6" (15.2 cm) I²C cable between the audio amplifier (either I²C jack) and the empty I²C jack on the bottom card of the X-Port 20 switch.

 

Supplied 6" (15.2 cm)

 

I²C Cable

Audio Amplifier

NOTE: Connect the I²C cable

 

to the empty I²C jack on the

 

bottom card of the X-Port 20

 

switch.

Connecting the Audio Amplifier to the X-Port Serial/Video Switch (Room Control Module Installed)

4.If you don’t have a Room Control Module installed, attach the supplied 6" (15.2 cm) I²C cable between the audio amplifier (either of the two I²C jacks) and the bottom card of the X-Port 20 switch (either of the two I²C jacks).

Supplied 6" (15.2 cm)

I²C Cable

Audio Amplifier

NOTE: Connect the I²C cable to either I²C jack on the bottom card of the X-Port 20 switch.

Connecting the Audio Amplifier to the X-Port Switch (Room Control Module Not Installed)

6

Installing an X-Port 20 Switch in a 2000i

99-00539-00 Rev B0

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Rev B0 FCC Warning Contents Rev A0 To mount the X-Port 20 switch This kit contains An antistatic wrist strapReplacing the Labels Location of Button Head ScrewsComponents of the X-Port 20 Switch Open Electronics TrayRerouting the DB9 Cable to the X-Port 20 Switch Installing the X-Port 20 Switch in the Electronics TrayRerouting the Ribbon Cable To connect the X-Port 20 switchRerouting the Room Control Module if applicable Supplied 6 15.2 cm Connecting the Video Cable to the X-Port 20 Switch Connecting the RBG 1 in Cable to the X-Port 20 SwitchConnecting the Video Cable to the Projector Connecting the Guest Laptop Cable Bundle to To connect a guest laptopIf the image on the screen is too large or too small Customer Support
Top Page Image Contents