Smart Technologies (XP20-2000i-B) manual Connecting the RBG 1 in Cable to the X-Port 20 Switch

5.Locate the tie-wrapped bundle of cables running along the underside of the cabinet. In this bundle is a video cable (labeled RBG 1 IN) that connects directly to the RGB IN port on the projector. Disconnect this cable from the back of the projector, carefully cut the tie wraps that hold the bundle together with a pair of wire cutters or sturdy scissors, and connect the cable to the Video IN port on the top card of the X-Port 20 switch.

X-Port 20 Switch

(Cables Not Shown for Clarity)

Video IN Port

Connect RBG1 IN

Cable Here

Connecting the RBG 1 IN Cable to the X-Port 20 Switch

6.Connect one end of the supplied 6' (1.8 m) HD15 cable to the Video OUT port on the top card of the X-Port 20 switch.

X-Port 20 Switch
(Cables Not Shown for Clarity)	Video OUT Port

Connect the Supplied

HD15 Cable Here

Connecting the Video Cable to the X-Port 20 Switch

7.Connect the other end of this cable to the RGB IN port at the back of the projector.

RGB IN Port

	OUT RGB	OUT AUDIO	IN	R
			VIDEO-S
CONTROL PC	USB(PC)			AUDIO
	IN RGB	AUDIO
				L/MONO

Connecting the Video Cable to the Projector

R	IN
	VIDEO

AUDIO

L/MONO

NOTE: Connection panel is depicted upside down (as installed)

99-00539-00 Rev B0 Installing an X-Port 20 Switch in a 2000i 7