Smart Technologies (XP20-2000i-B) manual Rerouting the DB9 Cable to the X-Port 20 Switch

Page 8

7.Unplug the DB9 cable from the serial controller and plug it into the gender changer on the bottom card of the X-Port 20 switch.

Unplug DB9 cable (From Resident Computer Serial Port)

Plug DB9 cable into gender changer on bottom card (connector not shown in image)

Serial Controller

X-Port 20 Switch

Rerouting the DB9 Cable to the X-Port 20 Switch

8.Using a Phillips No. 1 screwdriver, install the X-Port 20 switch on the studs in the electronics tray and secure it in place with the four supplied pan head screws and star washers.

Studs (x 4)

Star Washers (x 4)

Pan Head Screws (x 4)

X-Port 20 Switch

Installing the X-Port 20 Switch in the Electronics Tray

4

Installing an X-Port 20 Switch in a 2000i

99-00539-00 Rev B0

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Rev B0 FCC Warning Contents Rev A0 To mount the X-Port 20 switch This kit contains An antistatic wrist strapReplacing the Labels Location of Button Head ScrewsComponents of the X-Port 20 Switch Open Electronics TrayRerouting the DB9 Cable to the X-Port 20 Switch Installing the X-Port 20 Switch in the Electronics TrayRerouting the Room Control Module if applicable To connect the X-Port 20 switchRerouting the Ribbon Cable Supplied 6 15.2 cm Connecting the Video Cable to the Projector Connecting the RBG 1 in Cable to the X-Port 20 SwitchConnecting the Video Cable to the X-Port 20 Switch Connecting the Guest Laptop Cable Bundle to To connect a guest laptopIf the image on the screen is too large or too small Customer Support
Top Page Image Contents