Smart Technologies (XP20-2000i-B) To connect the X-Port 20 switch, Rerouting the Ribbon Cable

Page 9

To connect the X-Port 20 switch

1.Attach the loose end of the DB9 female-to-female ribbon cable to the serial controller using the two supplied machine screws. Secure the ribbon cable and serial cable in place, as shown below, using two of the supplied tie wraps.

Machine Screws (x 2)

Serial Controller

Loose End of

Ribbon Cable

Tie Wraps (x 2)

Serial Cable

Rerouting the Ribbon Cable

2.If you have a Room Control Module installed, disconnect the I²C cable (that runs between the audio amplifier and the Room Control Module) from the audio amplifier and connect it to the bottom card of X-Port 20 switch (either of the two I²C input jacks).

NOTE: If you don’t have a Room Control Module installed, proceed to step 4.

I²C Cable

Room Control Module

(Not Shown – Installed

Behind Audio Amplifier)

Disconnect the I²C cable from here. Then connect to the bottom card (either I²C jack) of the X-Port 20 switch.

Audio Amplifier

Rerouting the Room Control Module (if applicable)

99-00539-00 Rev B0

Installing an X-Port 20 Switch in a 2000i

5

Image 9

Contents Rev B0 FCC Warning Contents Rev A0 This kit contains An antistatic wrist strap To mount the X-Port 20 switchLocation of Button Head Screws Replacing the LabelsOpen Electronics Tray Components of the X-Port 20 SwitchInstalling the X-Port 20 Switch in the Electronics Tray Rerouting the DB9 Cable to the X-Port 20 SwitchTo connect the X-Port 20 switch Rerouting the Ribbon CableRerouting the Room Control Module if applicable Supplied 6 15.2 cm Connecting the RBG 1 in Cable to the X-Port 20 Switch Connecting the Video Cable to the X-Port 20 SwitchConnecting the Video Cable to the Projector To connect a guest laptop Connecting the Guest Laptop Cable Bundle toIf the image on the screen is too large or too small Customer Support