Smart Technologies (XP20-2000i-B) manual Open Electronics Tray, Components of the X-Port 20 Switch

Page 7

5.Carefully swing the electronics tray down so it hangs vertically.

Rear View of 2000i with

Back Legs Removed for Clarity

Electronics Tray

(Open Position)

Open Electronics Tray

6.Familiarize yourself with the components of the supplied X-Port 20 switch. In particular, take note of the I²C input jacks and the gender changer on the left side of the bottom card.

IMPORTANT

It is important to preserve the configuration of the X-Port 20 switch.

Do not remove the ribbon cable, gender changer or separate the two cards.

 

 

Video IN

Video OUT

 

I²C Input Jacks

(Top Card)

(Top Card)

 

(Top and Bottom

 

 

Top Card

Cards)

 

Serial OUT

 

 

 

Ribbon Cable

Bottom Card

 

 

(Installed on

 

 

 

Bottom Card)

 

Guest Laptop Video IN (Top Card)

Serial IN

Guest Laptop DB9 Serial IN (Bottom Card)

 

Gender Changer

 

(Installed on

 

Bottom Card)

 

 

Components of the X-Port 20 Switch

99-00539-00 Rev B0

Installing an X-Port 20 Switch in a 2000i

3

Image 7
Contents Rev B0 FCC Warning Contents Rev A0 This kit contains An antistatic wrist strap To mount the X-Port 20 switchLocation of Button Head Screws Replacing the LabelsOpen Electronics Tray Components of the X-Port 20 SwitchInstalling the X-Port 20 Switch in the Electronics Tray Rerouting the DB9 Cable to the X-Port 20 SwitchRerouting the Ribbon Cable To connect the X-Port 20 switchRerouting the Room Control Module if applicable Supplied 6 15.2 cm Connecting the Video Cable to the X-Port 20 Switch Connecting the RBG 1 in Cable to the X-Port 20 SwitchConnecting the Video Cable to the Projector To connect a guest laptop Connecting the Guest Laptop Cable Bundle toIf the image on the screen is too large or too small Customer Support