Smart Technologies (XP20-2000i-B) manual Replacing the Labels, Location of Button Head Screws

Page 6

2.Make sure the casters are locked and all four anti-tip feet are extended.

3.Remove the stickers covering the lower DB9 opening and the upper HD15 opening. Place the supplied serial (computer) label over the lower opening and the supplied video label over the upper opening, as illustrated below.

Video Label

Upper HD15 Opening

Lower DB9 (Computer)

 

Serial (Computer) Label

Opening

Replacing the Labels

4.While propping up the electronics tray with one hand (so it doesn’t fall suddenly), remove the two button head hex screws on either side of the tray using a 5/32" hex key (provided in the accessory kit for the 2000i). Put the hex screws in a safe place as you’ll need them to secure the electronics tray at the end of this installation.

Button Head Screw

Button Head Screw

Rear View of 2000i with

Back Legs Removed for Clarity

Location of Button Head Screws

2

Installing an X-Port 20 Switch in a 2000i

99-00539-00 Rev B0

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Rev B0 FCC Warning Contents Rev A0 To mount the X-Port 20 switch This kit contains An antistatic wrist strapReplacing the Labels Location of Button Head ScrewsComponents of the X-Port 20 Switch Open Electronics TrayRerouting the DB9 Cable to the X-Port 20 Switch Installing the X-Port 20 Switch in the Electronics TrayTo connect the X-Port 20 switch Rerouting the Ribbon CableRerouting the Room Control Module if applicable Supplied 6 15.2 cm Connecting the RBG 1 in Cable to the X-Port 20 Switch Connecting the Video Cable to the X-Port 20 SwitchConnecting the Video Cable to the Projector Connecting the Guest Laptop Cable Bundle to To connect a guest laptopIf the image on the screen is too large or too small Customer Support
Top Page Image Contents