Sanyo PLC-WM5500 Power is turned off, You cannot operate with, Side control, Remote Control does

Page 75

Appendix

 

– Power management function runs by initial setting. Check “Setting” section on page

 

59.

 

– When the filter cartridge replacement icon keeps appearing on the screen at turning

 

on the projector for some time and no action is taken to replace the filter cartridge, the

The power is turned off

projector will be automatically shut down in 3 minutes after turning on to protect the

automatically..

projector. (See pages 66, 81)

 

– Do not cover the ventilation slots on the projector. (See pages 4, 6)

 

– Projector may be used in high ambient temperature environment. Make sure the

 

temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–40˚C]). (See page

 

72)

You cannot operate with

– If the side control is locked at "Key lock" under "Security" of Setting menu, the side

the side control..

control is not available. Please check “Setting” section on page 61.

 

– Check the batteries.

 

– Check if the RC sensor is set properly. (See page 59)

 

– Make sure no obstruction is between the projector and remote control.

 

– Make sure you are not too far from the projector when using the remote control.

 

Maximum operating range is 16.4’ (5m). (See page 15)

The Remote Control does

– Make sure that the remote control code conforms to the projector’s code. (See

“SETTING” section on page 58.)

not work..

– Unlock the Key lock function for the remote control. (See page 61)

 

– Wireless remote control does not work when the remote control cable is connected to

 

the projector. (See page 15)

 

– Check if the ALL-OFF switch on the remote control is set to “ON.”

 

– Make sure that the simple mode in the remote control function is set to Off (See page

 

58).

Wireless mouse function

– Check the cable connection between the projector and your computer. (See pages 19,

32)

does not work..

– Check the mouse setting on your computer.

 

– Turn on the projector before you turn on the computer.

Indicators blink or light..

– Check the status of the projector with referring to “Indicators and projector condition” on

pages 79-81.

 

 

 

 

– Your operation is invalid. Operate correctly.

appears on the screen

 

Unable to unlock the Logo

 

PIN code lock, Security

– Contact the dealer where you purchased the projector or the service center.

key lock or Security PIN

 

code lock..

 

Forget the Logo PIN code

– Contact the dealer where you purchased the projector or the service center.

or Security PIN code..

 

WARNING:

High voltages are used to operate this projector.. Do not attempt to open the cabinet..

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

75

Page 74 Page 76
Image 75
Page 74 Page 76
Contents Network Supported Model PLC-WM5500 PLC-WM5500LFunctionally Rich Multilanguage Menu Display Features and DesignTable of Contents To The Owner Safety PrecautionSafety Instructions Top Panel Safety Instructions Air CirculationPositioning Precautions Safety Instructions Moving the Projector AC Power Cord for the United States and Canada AC Power Cord for the United KingdomCompliance Back Bottom ⑱ Adjustable FeetPart Names and Functions FrontKensington Security Slot ⑮ USB Connector Series BPart Names and Functions Rear Terminal ① Infrared remote receiver BackPart Names and Functions Side Control and Indicators Part Names and Functions Remote Control ⑯ Input 1- 3 buttons ⑳ RESET/ON/ALL-OFF switch㉕ P-TIMER button ⑮ D..ZOOM buttonWired Remote Control Transmitter Remote Control Receivers and Operating RangeAdjustable Feet Part Names and Functions Remote Control CodePositioning the Projector InstallationLens Shift Adjustment Lens shift adjustable rangeRemoving the lens Installation Lens InstallationInstallation Connecting to a Computer Digital and Analog RGB Input Terminal Analog Out Signal TableInstallation Connecting for Audio Signal For the U..S..A.. and Canada For Continental Europe Installation Connecting the AC Power CordProjector side For the U..KTurning On the Projector When using side controlWhen using remote control Basic OperationWhat is PIN code? Basic OperationTurning Off the Projector Basic Operation How to Operate the On-Screen Menu Remote ControlOn-Screen Menu Basic Operation Menu Bar Basic Operation Operating with Projector Control Lens OperationSide Control Basic Operation Sound Adjustment Direct OperationMenu Operation Information Menu Basic Operation Operating with Remote ControlAuto PC button Screen buttonFreeze button Timer buttonMouse Pointer button Pointer buttonBasic Operation Keystone Correction StandardCorner correction Click button Wireless Mouse OperationBasic Operation Pointer Function Dot Arrow FingerDirect Operation Side Control/Remote Control OperationRemote Control Operation Input SelectionRgbpc analog Input Selection Computer Input Source SelectionInput Selection Video Input Source Selection RGBScartVideo Pb/Cb,Pr/Cr Selecting Computer System Manually Computer InputComputer System Selection Automatic Multi-Scan SystemAuto PC adj Computer Input Auto PC AdjustmentPC adjust Menu To store the adjusted parametersComputer Input Manual PC Adjustment Store ResetMode free Computer InputReal Image select MenuDynamic StandardImage adjust Menu Computer Input Image AdjustmentScreen Size Adjustment Position H/V Custom adjDigital zoom + Digital zoomKeystone Ceiling Rear Pb/Cb, Pr/Cr Jacks Video InputVideo System Selection Video Jack or S-video JackCinema Video InputDynamic NaturalVideo Input Image Adjustment ColorTint Store Noise reductionProgressive Natural Wide Video Input Screen Size AdjustmentCustom adj Wide169Ceiling Language SettingSetting Setting Menu Language Input buttonBackground Logo Logo and Logo PIN code lock settingsLogo select DisplayLogo PIN code lock CaptureLogo PIN code lock Enter a Logo PIN code Change the Logo PIN code lock settingChange the Logo PIN code lock setting Enter a Logo PIN codePicture in Picture Hdmi setup Hdmi setupSound Lamp life control Lamp replacement iconLamp life control Lamp controlFan control Simple modeRemote control Filter controlPower management Standby modeRC sensor Timer Direct onPointer Security Key lock and PIN code lock Key lockPIN code lock Change the PIN code lock setting Enter a PIN codePIN code change Shutter CC3 or CC4 Video delay controlClosed caption Closed captionFilter counter Factory defaultFilter counter Test patternFilter Instructions Maintenance and CareRecommendation Maintenance and Care Replacing the Filter CartridgeScroll counter Reset? Maintenance and Care Resetting the Filter CounterResetting the Scroll Counter Filter counter Reset?Follow these steps to replace the lamp Maintenance and Care Lamp ReplacementMaintenance and Care Lamp Handling PrecautionsCleaning the Projector Cabinet Maintenance and Care Cleaning the Projection LensThen check the matters below Appendix TroubleshootingAppendix Indicators blink or light Power is turned offRemote Control does Wireless mouse functionAppendix Menu Tree Computer Input/HDMI Input/Video InputComputer Input Screen Hdmi Input/Video InputVideo Input ScreenSetting SettingAppendix Indicators and Projector Condition IndicatorsProjector is operating normally Lamp Replace Projector is detecting abnormal conditionReplacement icon appears on the screen and the Warning Display Appendix Compatible Computer SpecificationsWSXGA+ Mechanical Information Appendix Technical SpecificationsPJ Link Notice Lens ReplacementTo the sales and service engineers Appendix Optional PartsAppendix Configurations of Terminals InputOutput PIN Code Lock No Factory default set No 1 2 3Factory default set No 4 3 2 Appendix PIN Code Number MemoAppendix Dimensions Note Appendix List of Picture in PictureSerial Control Interface OperationFormat Functional Execution CommandStatus Read Command FormatEx. S1 = 12.3˚C, S2 = 23.4˚C, S3 = 34.5˚C KK8AL

PLC-WM5500, WM5500L specifications

The Sanyo WM5500L, also known as PLC-WM5500, is a high-performance projector designed to deliver exceptional image quality and versatility for various applications, including business presentations, educational use, and home entertainment. This projector integrates cutting-edge technology with user-friendly features, making it a popular choice among professionals and casual users alike.

One of the standout features of the Sanyo WM5500L is its impressive brightness. With a brightness rating of 5000 ANSI lumens, this projector is capable of delivering clear and vivid images, even in well-lit environments. This makes it an ideal choice for large venues such as auditoriums, conference rooms, and classrooms, where ambient light can be a challenge. The high brightness level ensures that images remain sharp and easy to read, regardless of the lighting conditions.

The projector employs advanced LCD technology, which is known for producing true-to-life colors and excellent contrast ratios. The Sanyo WM5500L features a resolution of 1024 x 768 pixels (XGA), providing a good balance between image detail and performance. The combination of high brightness and effective color reproduction makes it suitable for displaying presentations, videos, and images with a high degree of clarity and vibrancy.

Another notable characteristic of the WM5500L is its connectivity options. The projector is equipped with multiple input terminals, including HDMI, VGA, and composite video, allowing users to connect various devices such as laptops, Blu-ray players, and gaming consoles easily. This versatility ensures compatibility with a wide range of audio-visual equipment, making it an excellent choice for diverse usage scenarios.

In addition to its excellent image quality and connectivity, the Sanyo WM5500L is designed with user convenience in mind. It features adjustable lens shift capabilities, ensuring that users can position the projector flexibly without compromising image quality. The built-in 10-watt speaker enhances the audio experience, making it suitable for presentations that require accompanying sound without the need for external speakers.

Finally, the reliable durability of the Sanyo WM5500L, coupled with its energy-efficient design, ensures that users enjoy a long-lasting, cost-effective projection solution. Overall, the Sanyo WM5500L (PLC-WM5500) stands out in the market as a powerful, reliable projector that meets the diverse needs of its users, combining advanced technology, high-quality imaging, and ease of use. This projector is undoubtedly a valuable addition to any professional or educational setting.
Top Page Image Contents