Sanyo PLC-XT25 owner manual Indicators and Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for the projector condition.

WARNING TEMP. indicator

Indicators

POWER	LAMP	WARNING	Projector Condition
		TEMP.
green	red
		red
			The projector is off. (The AC power cord is unplugged.)
			The projector is in stand-by mode. Press the ON/STAND-BY button
			to turn on the projector.
			The projector is operating normally.
			The temperature inside the projector is abnormally high. The
			projector cannot be turned on. When the projector is cooled down
			enough and the temperature returns to normal, the POWER
			indicator lights red and the projector can be turned on. (The
			WARNING indicator keeps blinking.) Check and clean the filter.
			The projector has been cooled down enough and the temperature
			returns to normal. When turning on the projector, the WARNING
			indicator stops blinking. Check and clean the filter.
			The projector is preparing for stand-by or the projection lamp is
			being cooled down. The projector cannot be turned on until cooling
			is completed.
POWER, LAMP,			The projector detects an abnormal condition and cannot be turned
WARNING, FILTER,			on. Unplug the AC power cord and plug it again to turn on the
and LAMP REPLACE			projector. If the projector is turned off again, unplug the AC power
indicators are blinking			cord and contact the dealer or the service center. Do not leave the
all together.			projector on. It may cause an electric shock or a fire hazard.
			The projector is in the Power management mode.

• • • lighting • • • blinking • • • off

73