Sanyo PLC-XT25 owner manual Lamp Replace indicator, After resetting the counter

Appendix

WARNING FILTER indicator

Indicators

POWER		WARNING	Projector Condition
	LAMP	FILTER
green
	red	orange
			The filter is clogged with dust or has been used overtime. Clean or
			replace the filter immediately
			The filter has been used overtime. Clean or replace the filter
			immediately.

LAMP REPLACE indicator

Indicators

POWER	LAMP	LAMP	Projector Condition
		REPLACE
green	red
		yellow
			The lamp cannot light up. (The projector is preparing for stand-by or
			the projection lamp is being cooled down. The projector cannot be
			turned on until cooling is completed.)
			The lamp cannot light up. (The lamp has been cooled down enough
			and the projector is in stand-by mode and ready to be turned on with
			the POWER ON-OFF button.)
			The lamp has been used overtime. Replace the lamp immediately
			and then reset the lamp counter. The indicator will be turned off
			after resetting the counter.

*When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp counter after replacing the lamp. See page 58–59.

74