Sanyo PLCSW20AR owner manual Remote Control Unit, Does not work, Check the batteries

Page 42

APPENDIX

Problem:

Try these Solutions

Remote Control Unit

Check the batteries.

does not work.

Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.

Make sure you are not too far from a projector when using Remote Control Unit.

 

 

Maximum operating range is 16.4’ (5m).

 

Make sure the code of Remote Control Unit is set to conform to projector.

 

(See “SETTING” section on page 35, 36.)

 

 

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the projector or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

42

Image 42
Contents Model PLC-SW20AR To the Owner Safety Instructions Voor de klanten in NederlandCompliances Plummer Street, Chatsworth, CaliforniaTable of Contents Features and Design Compact DesignPreparation Name of Each Part of ProjectorSETTING-UP Projector Connecting AC Power CordFor Continental Europe Adjustable Feet Preparation Positioning ProjectorPreparation Moving Projector Terminals of Projector Connecting ProjectorUSB Connector Series B Audio ComputerTerminals Projector Connecting to ComputerConnecting Projector Audio Input External Audio Equipment Audio AmplifierConnecting to Video Equipment Operation of Remote Control Unit Before OperationLaser Pointer Function Remote Control Batteries Installation Used to select input source. P22 TOP Controls and IndicatorsUsed to turn the projector on or off. P19 Used to open or close Menu operation. P17HOW to Operate ON-SCREEN Menu Operating ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Before Operation Menu BAR Guide WindowTurning on Projector Basic OperationTurning on / OFF Projector Turning OFF ProjectorFocus Adjustment Adjusting ScreenZoom Adjustment Keystone AdjustmentBasic Operation No Show Function Sound AdjustmentTimer Function Direct OperationSelecting Computer System Computer InputSelecting Input Source Select Computer System ManuallyComputer Input Compatible Computer Specifications FreqKHz PC Adjust Menu PC AdjustmentAuto PC Adjustment Auto PC AdjComputer Input Manual PC Adjustment Display area H Closes PC Adjust MenuDisplay area Full screenImage Level Select Menu Picture Image AdjustmentImage Level Select Direct Image 1~4Computer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input VideoVideo PAL / Secam / Ntsc / NTSC4.43 / PAL-M / PAL-N Component Video Signal FormatSelecting Video System AV System Menu Video or S-VIDEOPicture level adjusted for the picture with fine tone User preset picture adjustment in Image Adjust Menu P33,34Cinema Video Input Image Level Adjustment Provides image at a normal video aspect ratio of 4 Provides image at a wide screen ratio of 16Setting Setting MenuSetting Menu Remote control To change the code of the Remote Control UnitPower management Lamp counter resetLamp Replacement AppendixLamp Replace Lamp Handling Precautions Appendix Lamp Replace CounterOperating Wireless Mouse InstallationOperating Wireless Mouse Maintenance AIR Filter Care and CleaningCleaning Projection Lens Troubleshooting Does not work Remote Control UnitSee Setting section on page 35 Check the batteriesTechnical Specifications Appendix Configurations of Terminals USB Connector Series BOptional Parts Page Page Page Part No 303 2498 1AA6P1P3691-- MS8AA