Hitachi CP-X1200 user manual Connecting The Power Supply, Adjusting The Projectors Elevator

Connecting The Power Supply

WARNING • Use extra caution when connecting the power cord as incorrect or faulty connections may result in fire and/or electrical shock. Please adhere to the “User’s manual –

Safety Guide” and the following.

•Only plug the power cord into outlets rated for use with the power cord’s specified voltage range.

•Only use the power cord that came with the projector. If it is damaged, contact your dealer to newly get correct one.

•Never modify the power cord. Never attempt to defeat the ground connection of the three-pronged plug.

•Make sure that you firmly connect the power cord to the projector and wall outlet.

1	Connect the connector of the power cord to
	the AC inlet of the projector.
	outlet.Firmly plug the power cord’s plug into the
2

AC Inlet Outlet

ConnectorPlug

Adjusting The Projector's Elevator

	WARNING • Do not touch about the lens and ventilation openings during use or
	immediately after use to prevent a burn.
	CAUTION • To prevent damaging the projector and injuring yourself, always
	hold the projector whenever using the elevator buttons to adjust the elevator feet.
1	Press and hold in the elevator buttons.
	Elevator buttons
2	Raise or lower the projector to the desired height and
	then release the elevator buttons.
	When you release the elevator buttons, the elevator
	feet will lock into position.
3	As necessary, you can also finely adjust the height of
	the projector by twisting the elevator feet by hand.

Elevator feet

4