Troubleshooting (continued)
Related Messages (continued)
Message | Description | |
|
| |
CLEAN THE AIR FILTER |
| |
| The time the filter timer has counted has reached 100 | |
POWER OFF FIRST, | hours. | |
THEN CLEAN THE AIR FILTER. | Please clear or change the air filter by referring to the section | |
AFTER CLEANING THE AIR | “Air Filter”. After caring for the air filter, please be sure to reset | |
FILTER, | the filter timer. | |
RESET THE FILTER TIMER. |
| |
|
| |
| The internal portion temperature is rising. | |
| Please turn the power OFF, and allow the unit to cool down at | |
| least 20 minutes. After the projector has sufficiently cooled | |
CHECK THE AIR FLOW | down, please make confirmation of the following items, and | |
then turn the power on again. | ||
| ||
| • Is there blockage of the air passage aperture? | |
| • Is the air filter dirty? | |
| • Does the peripheral temperature exceed 35°C? | |
|
| |
NO INPUT IS DETECTED | There is no input signal. | |
Please confirm the signal input connection, and the status of the | ||
ON *** | ||
signal source. | ||
| ||
|
| |
| The horizontal or vertical wavelength of the inputted | |
SYNC IS OUT OF RANGE | signal is outside of the response parameters of this | |
unit. | ||
ON *** fH *****kHz fV *****Hz | ||
Please confirm the specs for this unit or the signal source | ||
| ||
| specs. | |
|
|
42