Hitachi User Manual and Safety Guidelines for 42PD5000 Plasma Monitor

Page 4

Important

Please read this User's Manual thoroughly, especially the Safety Instructions on Page 4 to 7. Mis-use may cause damage to your plasma monitor, which could shorten its lifespan, or cause injury to yourself. Should you encounter any difficulty in the set-up or operation of your monitor, firstly refer to the Troubleshooting guide at the rear of this manual.

In the unlikely event of a problem occurring with your plasma monitor, switch off at the mains sockets, pull out the plugs, and contact your dealer immediately.

CAUTION

Under no circumstances remove the rear cover of your plasma monitor.

Never guess or take any chances with electrical equipment of any kind - it is better to be safe than sorry!

Software Notice

It is prohibited for the end user of this product to copy, reverse engineer or reverse compile the software included therein, save to the extent permitted by law.

Plasma Monitor

After the plasma monitor has been on for any length of time, you will notice that the screen becomes warm. Please note that this is normal. Sometimes the screen might have some tiny bright or dark spots. Please note that this is normal.

CAUTION

To prevent scratches or damages to the plasma screen, do not knock or rub the surface with sharp or hard objects. Clean the screen with a soft cloth moistened with warm water and dry with a soft cloth. A mild soap may be used if the screen is extremely dirty. Do not use harsh or abrasive cleaners!

CAUTION

Use a soft cloth to clean the cabinet and control panel of the monitor. When excessively soiled dilute a neutral detergent in water, wet and wring out the soft cloth and afterward wipe with a dry soft cloth.

Never use acid/alkaline detergent, alcoholic detergent, abrasive cleaner, powder soap, OA cleaner, car wax, glass cleaner, etc. especially because they would cause discoloration, scratches or cracks.

FEATURES

Large-screen, high-definition plasma display panel

The 42-inch colour plasma display panel, with a resolution of 1024

(H)x 1024(V) pixels, and the 32-inch colour plasma display panel with a resolution of 852(H) X 1024(V) pixels, creates a high-definition, large-screen (aspect ratio : 16:9) and low-profile flat display. Free from electromagnetic interferences from geomagnetic sources and ambient power lines, the panel produces high-quality display images free from colour misconvergence and display distortion.

High Performance Digital Processor

A wide range of personal computer signals can be handled, from 640 x 400, 640 x 480 VGA to 1600 x 1200 UXGA.

Easy-to-use remote control and on screen display system

The remote control included eases the work of setting display controls. Further, the on-screen display system, displays the status of signal reception and display control settings in an easy-to-view fashion.

Power saving system

The International ENERGY STAR® power saver feature saves power consumption automatically when input signals are not available. When connected to a VESA DPMS-compliant PC, the monitor cuts its power consumption while it is idle.

TruBass

TruBass, SRS and (O) symbol are trademarks of SRS Labs,Inc. TruBass technology is incorporated under license from SRS Labs, Inc.

About the Optional Video Unit

The following functions can be obtained by connecting the optional video unit.

(1)A composite/S terminal and two component terminals have been added. A composite video output terminal is also provided as a monitoring output.

(2)A wide range of devices other than personal computers can also be connected.

(3)A component input is possible to switch to RGB signals from the Menu screen.

(4)A SCART terminal is also provided for the signal of the European standard. It operates as composite/S/RGB input terminal, or video output terminal.

Options

Ask your local retail dealer for further details.

1.Desktop stand:

CMPAD23 (for 32”)

CMPAD25 (for 42”)

2.Plasma monitor speaker:

CMPAS03 (for 32”) bass reflex speaker unit with 16x4.5cm cone type speaker (colour: dark gray)

CMPAS03S (for 32”) same type to CMPAS03 (colour: light gray)

CMPAS14 (for 42”) 2 way speaker unit with one 2.5cm dome type tweeter and two 8cm round type woofers (colour: dark gray)

CMPAS14S (for 42”) same type to CMPAS14 (colour: light gray)

3.Video unit: CMPAVW1

An expansion unit for viewing video with this device.

2

Image 4
Contents 32PD5000 42PD5000 42PMA500 Remarque English Features Contents Safety Instructions About the SymbolsBe cautious of the power cord connection Be sure to keep safety ground connectionBe careful in handling the battery of the remote control To Earth Fuse Blue to Neutral Cord ClampSafety Instructions Precautions for the cable connection Precaution during transportationDo not physically impact the remote control Set the sound volume at a suitable levelComponent Names Main UnitHandling the Remote Control Remote controlLoading Batteries Installation Instructions InstallationAnti-tumble measures Securing to a wall or pillarConnecting to a PC Monitor rear panelPage Turning Power On and Off Operating InstructionsOperating Instructions Volume Adjustment Input SwitchingWhen a button is pressed, the volume adjustment Audio MuteInput Signal Screen Display Size SwitchingDisplay area selection diagram RGB input Using the Menu Screen On-screen display system Automatic Adjustment of Screen Position and the ClockOperating Instructions Independent Operation of Multiple Monitors ID NoPicture Menu Timer Menu Off Timer Min 30Min 60Min 120Min 90Min On TimerAudio Menu Selected charactersFunction Menu Setup Menu MovieOther Features Language MenuAutomatic Store Menu Display Registration conditionOther Features Signal Check Power Save ModeWhen the RGB, RGB2 input is selected Status Display ActionImage Retention of Plasma Display Methods to Reduce the Occurrence of Image RetentionAbout screen defects About residual imagesTroubleshooting Symptoms That Seemingly Appear to be FailuresSymptom Point to check Check the way the signal cable is connectedEnglish Troubleshooting Actions to Correct Abnormal Displays ExampleProduct Specifications Signal InputRGB terminal D-sub 15-pin connector Pin Input signalProduct Specifications Signal Input Recommended Signal ListWith Digital RGB signal input RGB1 input Pin Input signalWith Analog RGB signal input RGB2 input Supplement Connecting to a Video Imaging Device An example of connecting video imaging devicesWith DVI-STB and RGB component setup Optional Video Unit FunctionDisplay size selection diagram When you want toInput signal Display screen Remarks AV1 AV2 AV3 RGB2 RGB1 AV4Using a wide-screen monitor Position +Pictures Split Operating Instructions Displaying Multi PictureTime will display 2 pictures YNR Operating Instructions Picture Menu Film Mode PAL Comb FilterBlack Enhancement Auto Colour Colour Management MagentaRed YellowVideo Input System Colour SystemAV2 1st step AV2 2nd step Audio Input Scart OutputRGB2 1st step RGB2 2nd stepVideo input Input connector pin specifications Scart connector pin specificationsPin Signal PinProduct Specifications Recommended Signal List With R, G, B Video input AV2 and AV4 inputWith component input AV1, AV2 and RGB2-component input KHz MHzRemote control provided for the optional tuner unit Optional Tuner Unit FunctionYou may recall the picture mode by Picture mode is changed in followingPress this button to change input Surround On or Off Mode Pressing this button. Each time pressedButtons for Teletext Mode Precautions when connecting the antenna Connecting AntennaMonitor rear panel TV AV1 AV2 AV3 RGB2 RGB1 AV4 During TV modeAuto Full Zoom 149Zoom C149L Activating the Split mode from the TV screen Multi Picture button Multi Mode button ButtonPictures Split 4 pictures 12 pictures Select buttonsSound mode Off-timerPictures Display will go out in approximately 6 seconds TV positionFreeze button Picture FreezingSplit Strobe During TV mode AbcdeDuring Video signal input Operating Instructions Setup MenuAuto Off Other Functions A2 / Nicam / Sound MultiplexBilingual / Dual sound broadcast Stereo sound broadcastMode button Index button TV / Text button Cancel button Operating Instructions Other FunctionsDVD Player Selection ExampleSymptom Possible reason Remedy Snowy picture poor soundMultiple images sound O.K Intermittent interferenceRF input Input signals Input terminals Parts packing To dealers and shopsParts for CL37-PD2100 only General Required general Disassembly ProhibitedForbidden General Installation on a wooden wall Installation on a concrete wallDo not install Locations where thereM6 x 18 screw x Cutout Wall-mount metal top CenterBottom Wall-mount metalMounting the wall-mount unit on the wall Installing the TV-mount metals Wire clampsRemove the stand Remove the 4 screws Remove the screws CL37-PD2100 StandM6 x 18 screws Bracket 1st TV-mount Metal hole TV-mount metal M6 x 18 screws2nd TV-mount metal hole 5th TV-mount metal hole External Dimensions Angle adjustmentMass Main materialModel Serial Number DEALER/STORE Date Purchased Hitachi Atago Building
Related manuals
Manual 76 pages 6.24 Kb