Installation Location
WARNING
Plaster board or thin ply wood, etc.
Pillar or
thick ply wood.
■The wall where the
Incorrect installation can cause the plasma TV to fall and cause injury.
Total load of the (plasma TV +
=
●Installation on a wooden wall
Always install so that the load is supported by a pillar. If the strength of the pillar is insufficient, add reinforcement. Do not install on decorative posts or plaster board.
●Installation on a concrete wall
Use commercially available anchors that are capable of fully supporting the load of the plasma TV.
CAUTION
■ Avoid installing in |
| ■ Do not block the | |
locations where the |
| 10cm | ventilation holes. |
temperature and |
| or more | Also provide |
|
| ||
humidity are |
|
| sufficient clearance |
excessively high, | 10cm |
| in regard to the |
and where contact | or more |
| surroundings to |
with water is |
|
| avoid blocking the |
possible. |
| 10cm | ventilation. |
These can result in fire |
| or more | The internal |
or electrical shock. |
|
| temperature could |
|
|
| elevate and possibly |
|
|
| result in fire. |
■ Do not install close |
| ■ Install only on a | |
to an air- |
|
| vertical surface. |
conditioner intake |
|
| Avoid sloped |
or outlet. |
|
| surface. Also, do |
Do not install in |
|
| not install facing |
locations where there |
|
| upward. |
is excessive amounts |
|
| The internal |
of dust, oily smoke or |
|
| temperature could |
tobacco smoke. |
|
| elevate and possibly |
Fire could result. |
|
| result in fire. |
|
|
| Injury or damage could |
|
|
| also result from falling. |
– 3 –