Hitachi 42PMA500, 42PD5000, 32PD5000 System Colour System, Video Input, AV2 1st step AV2 2nd step

OPERATING INSTRUCTIONS (continued)

SETUP MENU

MENU

Selected characters

System

Colour System

AV1

AV2

AV3

AV4

Video Input

AV1

AV2 (1st step)

AV2 (2nd step)

AV4

Picture			Setup				Setup
Audio		OK		System	System 1			Colour System
Timer						OK
				Colour System
Function				Video Input				AV1	Auto
Setup				Audio Input				AV2	PAL
Language				Scart Output	Monitor			AV3	SECAM
Select				RGB1	DVI-STB			AV4	PAL
OK	Set			RGB2	Component
					HDTV			Select	Return	Exit
				Select OK Set	Return

Setup		Setup
System	System 1	Video Input
Colour System		OK
Video Input		AV1	Auto
Audio Input		AV2	Composite/Component
Scart Output	Monitor	AV3	Auto
RGB1	DVI-STB	AV4	S.Video
RGB2	Component
	HDTV
Select OK Set	Return	Select	Return	Exit

Setup		Setup
System	System 1	Audio Input
Colour System	OK	AV1	Stereo
Video Input		AV2	L/Mono
Audio Input		AV3	Stereo
Scart Output	Monitor	AV4	L/Mono
RGB1	DVI-STB	Select	Return	Exit
RGB2	Component
	HDTV
Select OK Set	Return

▼				▼	Setup hint
	System1		System2		Do not change the original setting.
					(System1 : Europe/Asia, System2 : North America)
					This should correspond to the colour system of the signal from the
					equipment that is connected to AV1 video input terminal.
Auto		PAL		SECAM	• Normally, set this to Auto. The system of the input signal will be
					automatically recognized.
NTSC3.58			NTSC4.43		• If the input signal contains much noise or has a low level at Auto and the
					operation is found erratic, set this to match the input signal.

•When the component signal is received, this would be not available (grayed out).

(Same to AV1)

			This should correspond to the signal mode of the signal from the
			equipment that is connected to AV1 video input terminal.
Auto	HDTV	SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
			automatically recognized.

•If the input signal contains much noise or has a low level at Auto and the operation is found erratic, set this to match the input signal.

RGB		Composite/Component			This should correspond to the signal mode of the signal from the
					equipment that is connected to AV2 video input terminal.
Auto		HDTV		SDTV/DVD	This step should be set only when [Composite/Component] is selected on
					the 1st step. And the procedure is same to AV1.
					• If the signal from the equipment that is connected to AV4 Scart input
	S.Video		Composite		terminal is S.Video or Composite, set this to correspond to that signal.

•If the signal is RGB, it will be automatically recognized and this setting will have no effect.

38