JBL DD66000 manual Grille Removal

Page 16

VI.

Cut tapes at the corners of the bottom cardboard (drawing VI), slide

 

out the loudspeaker system toward you together with bottom endpads

 

(drawing VI-2).

 

 

VII.

Lift the system slightly on the right and left in turn to remove bottom

 

endpads .

 

 

VIII.

Remove the protective non-wovens.

 

VI

VI-2

VII

VIII

Products are shipped with round-tipped spikes on the bottom of the cabinet. If you would like to use pin -point spikes, please refer to figure 6 on page 12, and remove round-tipped spikes and replace them with pin -point spikes. In case, it is hard to loosen, please use 18mm size spanner/wrench.

Four metal coasters are also provided. These are to be placed between the foot and the floor should further protection of the floor coverings be required.

Grille Removal

The EVEREST DD66000 is shipped with its grille on the system. You can remove the grille in the following procedures.

Step 1: Hold the lower parts of the grille with both hands and pull it up.

Step 2: Pull the grille toward you in order to take the grille out of the pins from the cabinet.

Step 3: Pull the grille down and remove the grille from the cabinet.

Repeat the above procedures in a reverse order in order to install the grille back to the cabinet.

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Project Everest DD66000 Users Guide Table of Contents Chapter Defining the Project Concept Project Everest DD66000 Page Project Everest DD66000 Chapter Project Everest DD66000 1501AL Low Frequency Driver 1501AL section view476Be High Frequency Compression Driver and Horn 476Be section viewPage 045Be-1 Ultra-High Frequency Compression Driver and Horn 045Be-1 section viewInternal Crossover Network DD66000 system impedanceUnpacking the Project Everest DD66000 System Grille Removal Selecting Cable Amplifier Recommendations Placement and Set-up Considerations Floor Requirements Project Everest DD66000 Switch Operations System OrientationHF Drive / LF Drive HF Level LF LevelBattery Installation Project Everest DD66000 Project Everest DD66000 Connections II. Bi-Wire Connecting Method Passive Connecting MethodIII. Bi-Amp Connecting Method Final Checklist Project Everest DD66000 Care and Maintenance Troubleshooting and Service Guide Project Everest DD66000 Register Project Everest DD66000 System Specifications JBL and Harman International USA

DD66000 specifications

The JBL DD66000 is a flagship model in the world of high-fidelity loudspeakers, designed to deliver an exceptional listening experience for audiophiles and music enthusiasts alike. With its rich heritage rooted in decades of acoustic engineering expertise, the DD66000 represents the pinnacle of JBL's commitment to superior audio performance.

One of the standout features of the DD66000 is its innovative three-way speaker configuration. This includes a 15-inch bass driver, a 4-inch midrange driver, and a high-frequency compression driver that produces crystal-clear treble. This arrangement allows for a wide frequency response, ensuring that every note, from the lowest lows to the highest highs, is reproduced with remarkable accuracy and detail.

The DD66000 boasts advanced technologies that enhance its performance. The Integrated Waveguide Technology ensures that sound is evenly distributed throughout the listening space, creating a spacious and immersive soundstage. This technology minimizes distortion and ensures that the sound maintains its clarity, even at high volumes. Additionally, the dual high-frequency compression drivers provide extended dynamic range, allowing the speaker to handle both quiet and loud passages seamlessly.

Another key characteristic of the JBL DD66000 is its robust build quality. The speaker is encased in an elegantly crafted cabinet that not only minimizes resonance but also adds to its aesthetic appeal. The sleek design incorporates high-quality materials, giving it a premium look that complements any audio setup.

The DD66000 is also versatile in its connectivity options. Designed to work seamlessly with various audio components, it features compatibility with both analog and digital sources. Audiophiles can enjoy their favorite music in high-resolution formats, ensuring that every detail is captured and enjoyed.

In summary, the JBL DD66000 is a masterful integration of advanced technology and superior craftsmanship. With its three-way configuration, cutting-edge sound dispersion technology, and solid build quality, it stands out as a premier choice for serious listeners. Whether used in a dedicated home theater or a high-end audio setup, the DD66000 promises to deliver an unrivaled listening experience, making it a worthy investment for those who demand the best in audio fidelity.
Top Page Image Contents