Installation
Typical LCD Projector and Screen Installation
Use the diagram below as reference to determine the screen size and projection distnace.
| S | _h | |
To_D view | _) | Side view | ) |
) | \_ | ) | |
Screen |
|
|
|
/
a. Distance from the LCD projector to the screen
| a (inches) |
| b.Distance | from the | lens | center | to the | bottom | of | ||
Screen size | (inches) |
| b (inches) | ||||||||
|
|
|
|
|
|
|
| ||||
| Minimum | Maximum |
| the screen (a,b : |
|
|
| ||||
|
|
|
|
|
|
| |||||
4O | 55 | 73 | 1 | (Caution) |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
6O | 85 | 114 | 2 | The LCD | projector | should normally | be used | ||||
|
|
|
| ||||||||
8O | 114 | 151 | 2 | level (the legs can point | upward). |
|
|
| |||
100 | 144 | 191 | 3 | Positioning | the projector | sideways, or with | the | ||||
lens pointing upward or downward can cause the | |||||||||||
120 | 176 | 231 | 3 | ||||||||
internal temperature to rise, which could result in | |||||||||||
|
|
|
| ||||||||
150 | 220 | 282 | 4 | a malfunction. |
|
|
|
|
| ||
200 | 291 | 386 | 6 | The projection distances | shown | in the | diagram | to | |||
|
|
|
| the left are for full size (800 x 600 dots). |
|
| |||||
Using the adjusters ]
Use the adjusters on the bottom to adjust the projection angle.
f |
| , |
| Side view |
( | Front view | J ) | __ | \ |
| \\ |
Adjuster | Variable within the range of approximately 0° - 9 ° |
1.Lift up the projector and release the adjuster lock.
2.After adjusting the projection angle, firmly lock the adjusters.
3.Rotate the adjusters for fine adjustment.
IAkCautionl • Do not release the locks unless the projector is being held; otherwise, the projector could overturn or the fingers could get caught and cause personal injury.
•Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
•Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
12