Hitachi CPX960WE user manual Basic operations, To project

Page 13

Basic operations

To project 1

m

5 7 4 2

5_j4

1

_

1 Turn on the main power switch of the projector [ I: ON].

The Power indicator lights orange.

2 Press the STANDBY / ON button.

The Power indicator will blink green and then light green.

The green blinking indicates warmup.

After the power is turned on, the lamp will be cooled for approximately 1 rain. and the power cannot be turned on even by pressing the STANDBYJON button.

3

4

5

Remove the lens cap.

Use the ZOOM button to adjust the screen size.

Use the FOCUS button to adjust the focus.

( 1) The

display

shown to the right will appear when

the FOCUS button is pressed.

+ + + FOCUS+ + +

(2)

Use the FOCUS button to adjust the focus until the image is sharp.

 

(3)

The

message

"Focus" will disappear if any other

button is pressed.

 

• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)

6

7

Turn on the power to the connected equipment.

Refer to page 31 concerning the connection of other equipment.

Press either

the INPUT button of the

Exampleon-screendisplay

projector or the VIDEO/RGB button of the

 

remote control to select the signal to be

RGB 1

 

projected on the

screen.

 

The selected signal input channel will be displayed in the lower right part of the screen.

13

Image 13
Contents Contents FeaturesOutline Page Before Use Avoid shock or impact on Do not install on an unstable surfaceProjector Do not allow the laser beam to enter Eyes Do not position the power Cord under the projector. This canWhen disconnecting Power plug, do not pull on the power Do not touch the power plug with wet hands because thisUse the caster brakes Do not place heavy objects on this ProjectorMoving the projector Names and functions of each part Checking the package ContentsAudio OUT Names and functions of each partP button *2 Remote control transmitterVideo RGB LaserBattery Cover TCaution Battery usage cautions BatteryCover Typical LCD Projector and Screen Installation InstallationUsing the adjusters ToD view Side viewTo project Basic operationsPlug & Play Turning off the powerPress the STANDBY/ON button for approximately 1 sec Basic operations Cancelling the Freeze functionFreeze Press the Freeze buttonMoving the display area Changing the magnification ratioReturning to normal display Returning to the initial settings Adjustments and functionsUsing the Setup Menu Adjustments and functionsAdjustment item Moves the image up and downSystem. When the screen is unstble no color Adjustment item Adjustment descriptionVideo Blank KeystoneStart UP COM. Speed TimerAuto OFF Sync onConnection to the RGB signal terminal Connection to the video signal terminalsInput signals Signal Input jacksExample of computer signal Connectiontothe RGBsignalterminalResolution Signal mode Display ModeHorizontal signal timing Computer/Signal Timing Initial set signalsVertical signal timimg lines Connecting the USB Mouse functions Connection to the control signal terminalMouse Mouse cable Product name ModelSerial mouse Signal JackMouse 610 RS232C communicationSystemvideo Command Data ChartSize Color Balance RRequesting projector status When data sent by the projector cannot be understoodCleaning the Air filter Example of system setupFilterModel Screen displays LampIndicators When you think something wrongSymptom Possible cause Message tableControl Dimensional DiagramAbout the warranty About the warranty and after-serviceAbout after-service About repairs during the warranty period