Hitachi IPJ-AW250NM user manual Changing the frequency of remote control signal, USB Type B port

Page 17

Remote control

Changing the frequency of remote control signal

The accessory remote control has the two choices on signal

 

ASPECT

AUTO

SEARCH

BLANK

frequency Mode 1:NORMAL and Mode 2:HIGH. If the remote control

 

ON

FREEZE

UP

VOLUME

 

 

MAGNIFY

PAGE

does not function properly, attempt to change the signal frequency.

(2)

OFF

 

DOWN

MUTE (1)

In order to set the Mode, please keep pressing the combination of

KEYSTONE

MY 1

2

 

 

BUTTON

 

two buttons listed below simultaneously for about 3 seconds.

 

- FOCUS +

- D-ZOOM +

(1) Set to Mode 1:NORMAL... VOLUME - and RESET buttons

 

POSITION

 

 

MENU

(2) Set to Mode 2:HIGH... MAGNIFY OFF and ESC buttons

 

 

ENTER

 

Please remember that the REMOTE FREQ. in the SERVICE item of

 

ESC

 

 

RESET

 

 

 

 

 

the OPTION menu ( 62) of the projector to be controlled should be

 

 

 

 

 

set to the same mode as the remote control.

 

 

 

 

 

Using as a simple PC mouse & keyboard

The accessory remote control works as a simple mouse and keyboard of the computer, when the projector’s USB TYPE B port and the computer’s type A USB port are connected and MOUSE is selected for the USB TYPE B item in the OPTION menu (56).

(1)PAGE UP key: Press PAGE UP button.

(2)PAGE DOWN key: Press PAGE DOWN button.

(3)Mouse left button: Press ENTER button.

(4)Move pointer: Use the cursor buttons ▲, ▼, ◄ and ►.

(5)ESC key: Press ESC button.

(6)Mouse right button: Press RESET button.

USB TYPE B

USB TYPE B port

MY SOURCE/

VIDEO COMPUTER DOC.CAMERA

ASPECT AUTO SEARCH BLANK

MAGNIFY FREEZE PAGE

VOLUME

UP

 

ON

 

DOWN

OFF

(1)

(2)

 

 

KEYSTONE MY BUTTON MUTE

NOTICE ►Improper use of the simple mouse & keyboard

 

1

2

(3)

- FOCUS +

- D-ZOOM +

function could damage your equipment. While using this

POSITION

MENU

function, please connect this product only to a computer. Be

 

ENTER

 

sure to check your computer’s manuals before connecting this

(5)

ESC

RESET

product to the computer.

 

 

 

 

 

(4)

(6)

NOTE When the simple mouse & keyboard function of this product does not work correctly, please check the following.

When a USB cable connects this projector with a computer having a built-in pointing device (e.g. track ball) like a laptop Computer, open BIOS setup menu, then select the external mouse and disable the built-in pointing device, because the built-in pointing device may have priority to this function.

Windows 95 OSR 2.1 or higher is required for this function. And also this function may not work depending on the computer’s configurations and mouse drivers. This function can work with the computer which can operate general USB mouse or keyboard.

You cannot do things like press two buttons at once (for instance, pressing two buttons at the same time to move the mouse pointer diagonally).

This function is activated only when the projector is working properly. This function is not available in any of the following cases:

- While the lamp is warming up. (The POWER indicator blinks in green.) - When either USB TYPE A or USB TYPE B port is selected.

- While displaying BLANK (28), TEMPLATE (53) or MY IMAGE (69) screen. - When any menu is displayed on the screen.

- While using the cursor buttons to operate the sound or screen functions such as adjusting the sound volume, correcting the keystone, correcting the picture position and magnifying the screen.

17

Image 17
Contents Projector About this manualThank you for purchasing this projector Trademark acknowledgmentContents Checking the contents of package FeaturesProjector Part namesHOT LargeButtons Focus +/- buttons Control panel STANDBY/ON buttonHdmi Computer IN2 1415Computer button Down button Volume + buttonMY Button 1 button MY Button 2 button Keystone button Zoom button Zoom + button Position button 26Arrangement Setting upArrangement Connecting with your devices VCR/DVD/Blu-ray Disc Player Computer About Plug-and-Play capabilityConnecting with your devices USB storage Device Monitor Microphone systemHdmi Access point ComputerUsing the security bar and slot Connecting to a power supplySecurity bar Anti-theft chain or wire Security slotUsing the cable cover Installing the batteries Remote controlAbout the remote control signal Hitachi MAXELL, Part No.LR6 or R6PUSB Type B port Changing the frequency of remote control signalUsing as a simple PC mouse & keyboard Interactive pen Installing the batteryExchanging the tip of the pen Hitachi MAXELL, Part No. LR03STANDBY/ON button Power indicator Power on/offTurning on the power Turning off the power Selecting an input signal Adjusting the volumeOperating Temporarily muting the soundComputer button Press the MY Source / DOC. Camera button onVideo button MY SourceFor a computer signal Searching an input signalFor an Hdmitm signal Selecting an aspect ratioAdjusting the zoom and focus Adjusting the projectors elevatorZoom button Zoom + buttonFor a video signal and s-video signal Using the automatic adjustment featureFor a component video signal Focus buttonCorrecting the keystone distortions Adjusting the positionPosition button Keystone buttonMagnify ON/OFF button Using the magnify featureTemporarily blanking the screen Temporarily freezing the screenFreeze button Blank buttonESC button Reset button Using the menu functionAdvanced Menu Enter buttonIndication Meaning Indication in OSD On Screen DisplayInteractive DescriptionAspect ZoomECO Mode Picture ModeReset MirrorInteractive menu Brightness Picture menuContrast GammaLOW Custom MIDCustom ColorPresentation SharpnessOFF Active IrisImage menu For a computer signalFor an Hdmitm signal Selected will reset the H Position to the default setting Signal, the range of this adjustment depends on Over ScanPosition USB Type B or Hdmi portAuto Adjust PhaseSize ExecuteTV Film OFF Input menuHigh MID LOW Video NRHdmi Range Video FormatHdmi Format Frame Lock Auto Sync on G OFFComputer Resolution Shift Setup menuLeft MID Right No Input is Detected Sync is OUT of Range Invalid Scan FreqOn OFF Perfect FIT Input buttonNormal Saving Normal ECONormal Hinvert Vinvert Audio menu VolumeSpeaker Audio SourceHdmi Audio MIC VolumeMIC Level High LOWEnglish Français Deutsch Español Screen menuMyScreen registration is finished Capturing error has occurred. Please try againMyScreen Message MyScreen LockSource Name Template Display Description Closed CaptionMode ChannelComputer IN2 LAN USB Type a Video Video Hdmi USB Type B Direct PowerOption menu OFF Auto PowerMouse USB Display USB Type BLamp Time Cancel OKCancel No Messenger Data appears MY ButtonPicture Mode Changes the Picture Mode Active Iris Changes the active iris modeZoom Turns the D-ZOOM mode on/off. When the D-ZOOM Mode is on, use the / cursor buttons to adjustFAN Speed ServiceGhost Filter MessageLens Door Lock KEY LockLens Door Open Lens Door CloseControl port Remote Freq1NORMAL 2HIGH Baud Rate Service Serial SettingsCommunication Type ParityTransmission Method Response Limit TimeInformation Factory ResetDhcp SetupNetwork menu Setup Gateway DefaultIP Address SubnetProjector Name AMX D.D MY ImagePresentation QuitPresenter User Name Section SwitchingMulti PC Guide Security menu PasswordEnter to the Security menu SecurityMyScreen Turning on the MyScreen PasswordTurning off the MyScreen Password Turning on the PIN Lock PIN LockTurning off the PIN Lock If you have forgotten your PIN codeTurning off the Transition Detector Transition DetectorTurning on the Transition Detector Turning off the MY Text Password MY Text PasswordTurning on the MY Text Password Writing MY TextInteractive Function Presentation toolsSystem requirements ApplicationInteractive Function Connection during use Preliminary preparation Using the penCustomizing the pen Basic pen operationUsing StarBoard Software Supported storage media PC-LESS PresentationSupported format Supported file formatThumbnail menu Selected image Thumbnail images Thumbnail modeOperating by buttons or keys Setup menu for the selected imageDown Enter InputOperating by the menu on the Thumbnail screen PC-LESS Presentation Full Screen Mode Control Projector Software Slideshow modePlay Example of playlist.txt files PlaylistUSB Port USB cable 1 piece USB DisplayHardware and software requirement for computer Floating menu Right-Click menuOptions window Replacing the lamp MaintenanceType number DT01181 Replacing the lampLamp warning High Voltage High TemperatureStitched side On next Cleaning and replacing the air filterType number UX37191 Filter set 100 Cleaning and replacing the air filter101 Replacing the internal clock batteryHitachi MAXELL, part number CR2032 or CR2032H 102 Cleaning clothMaintenance of the pen sensors horns Caring for the cabinet and remote controlMaintenance of the pen Inside of the projector104 Other careThere is no input signal TroubleshootingAn improper signal is input Related messages106 Internal temperature is risingButton operation is not available Regarding the indicator lamps There is a possibility that the interior portion It is time to clean the air filterHas become heated Lens door is not opened properlyResetting all settings Volume is adjusted to an extremely low level Signal cables are not correctly connectedAudio SOURCE/SPEAKER setting is not correct Mode selected for Hdmi Audio is not suitableColor Space setting is not suitable Color settings are not correctly adjustedProjector is operating in Eco mode Frame Lock function cannot work on the current Input signalSaving function is working Computer cannot start up in the current hardwareCommunication Type for the Control port is Set to Network BridgeIs the power of the projector turned on? Is the use of USB cables disabled?Is the USB cable connected correctly? Is the system started up in the correct sequence?Has the battery run out? This may be due to poor contact of the batteryAre you using more than one pen at the same time? Is the volume from the speaker of the projector too loud?Is the tip of the pen worn out? StarBoard Software files may be corrupted, orIs alignment of the pen position correctly performed? Is the projector inclined?Is the computer image projected within the area Screen? Is the projector correctly installed?Is a part of the image enlarged using the Magnify Function? 117 SpecificationsEnd User License Agreement for the Projector Software
Related manuals
Manual 2 pages 39.75 Kb

IPJ-AW250NM specifications

The Hitachi IPJ-AW250NM is an advanced interactive projector that caters to the needs of modern classrooms and meeting spaces. Designed for versatility and ease of use, it combines vivid image quality with innovative features that enhance collaboration and engagement.

One of the standout features of the IPJ-AW250NM is its impressive brightness level, reaching up to 2500 lumens. This ensures that images remain clear and vibrant even in well-lit environments, making it perfect for various applications. Whether used for presentations, educational purposes, or interactive workshops, the projector provides consistent performance.

Resolution-wise, the IPJ-AW250NM offers WXGA (1280 x 800) resolution, delivering sharp and detailed visuals. This resolution is particularly beneficial for displaying text-heavy content, such as spreadsheets and documents, as well as multimedia presentations, ensuring that every detail is easily visible to the audience.

In terms of interactivity, the IPJ-AW250NM is equipped with Hitachi's advanced interactive features, allowing users to engage with the content directly on the projection surface. This capability fosters collaboration among participants, as multiple users can interact simultaneously, making it ideal for brainstorming sessions and group activities.

The projector incorporates advanced technologies such as HDMI connectivity, allowing for seamless integration with various devices like laptops, tablets, and multimedia players. This flexibility enhances the user experience, enabling quick and easy setup for any presentation scenario.

Additionally, the IPJ-AW250NM boasts a long lamp life of up to 5000 hours in standard mode, significantly reducing maintenance and replacement costs over time. The projector also includes various Eco modes that optimize energy efficiency while maintaining quality output.

Portability is another highlight of the IPJ-AW250NM, as it is designed for easy transport between locations. Its lightweight design, combined with a compact structure, makes it convenient for users who need to move the projector between different classrooms or offices effortlessly.

Overall, the Hitachi IPJ-AW250NM interactive projector stands out for its combination of high brightness, interactive capabilities, and user-friendly features. Whether in education or business, it presents an opportunity to transform presentations and foster collaborative environments, ultimately enhancing the overall effectiveness of communication.