Hitachi IPJ-AW250NM Option menu, Computer IN2 LAN USB Type a Video Video Hdmi USB Type B

Page 55

OPTION menu

OPTION menu

From the OPTION menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table.

Item

Description

Using the ▲/▼ buttons turns on/off the automatic signal search

function.

 

 

ON OFF

 

 

When the ON is selected, detecting no signal automatically cycles

through input ports in the following order. The search is started from

AUTO SEARCH the current port. Then when an input is found, the projector will stop

searching and display the image.

 

COMPUTER IN1

COMPUTER IN2

LAN USB TYPE A

VIDEO

S-VIDEO HDMI

USB TYPE B

•It may take several seconds to project the images from the USB TYPE B port.

 

Using the ▲/▼ buttons turns on/off the DIRECT POWER ON

 

function.

 

ON OFF

 

When set to the ON, the lamp in projector will be automatically turned

DIRECT POWER

on without the usual procedure ( 19), only when the projector is

supplied with the power after the power was cut while the lamp was on.

ON

• This function does not work as long as the power has been

 

supplied to the projector while the lamp is off.

•After turning the lamp on by the DIRECT POWER ON function, if neither input nor operation is detected for about 30 minutes, the

projector is turned off, even though the AUTO POWER OFF function (56) is disabled.

(continued on next page)

55

Page 54 Page 56
Image 55
Page 54 Page 56
Contents
Trademark acknowledgment About this manualProjector Thank you for purchasing this projectorContents Checking the contents of package FeaturesLarge Part namesProjector HOT1415 Control panel STANDBY/ON buttonButtons Focus +/- buttons Hdmi Computer IN2Zoom button Zoom + button Position button 26 Down button Volume + buttonComputer button MY Button 1 button MY Button 2 button Keystone buttonArrangement Setting upArrangement Connecting with your devices VCR/DVD/Blu-ray Disc Player Computer About Plug-and-Play capabilityConnecting with your devices USB storage Device Monitor Microphone systemHdmi Access point ComputerSecurity slot Connecting to a power supplyUsing the security bar and slot Security bar Anti-theft chain or wireUsing the cable cover Hitachi MAXELL, Part No.LR6 or R6P Remote controlInstalling the batteries About the remote control signalUsing as a simple PC mouse & keyboard Changing the frequency of remote control signalUSB Type B port Hitachi MAXELL, Part No. LR03 Installing the batteryInteractive pen Exchanging the tip of the penTurning on the power Power on/offSTANDBY/ON button Power indicator Turning off the power Temporarily muting the sound Adjusting the volumeSelecting an input signal OperatingMY Source Press the MY Source / DOC. Camera button onComputer button Video buttonSelecting an aspect ratio Searching an input signalFor a computer signal For an Hdmitm signalZoom + button Adjusting the projectors elevatorAdjusting the zoom and focus Zoom buttonFocus button Using the automatic adjustment featureFor a video signal and s-video signal For a component video signalKeystone button Adjusting the positionCorrecting the keystone distortions Position buttonMagnify ON/OFF button Using the magnify featureBlank button Temporarily freezing the screenTemporarily blanking the screen Freeze buttonEnter button Using the menu functionESC button Reset button Advanced MenuIndication Meaning Indication in OSD On Screen DisplayZoom DescriptionInteractive AspectMirror Picture ModeECO Mode ResetInteractive menu Gamma Picture menuBrightness ContrastColor Custom MIDLOW CustomActive Iris SharpnessPresentation OFFFor an Hdmitm signal For a computer signalImage menu USB Type B or Hdmi port Signal, the range of this adjustment depends on Over ScanSelected will reset the H Position to the default setting PositionExecute PhaseAuto Adjust SizeVideo NR Input menuTV Film OFF High MID LOWHdmi Format Video FormatHdmi Range Computer Auto Sync on G OFFFrame Lock Resolution No Input is Detected Sync is OUT of Range Invalid Scan Freq Setup menuShift Left MID RightOn OFF Perfect FIT Input buttonNormal Hinvert Vinvert Normal ECONormal Saving Audio Source VolumeAudio menu SpeakerHigh LOW MIC VolumeHdmi Audio MIC LevelEnglish Français Deutsch Español Screen menuMyScreen Capturing error has occurred. Please try againMyScreen registration is finished Message MyScreen LockSource Name Template Channel Description Closed CaptionDisplay ModeOption menu Direct PowerComputer IN2 LAN USB Type a Video Video Hdmi USB Type B USB Type B Auto PowerOFF Mouse USB DisplayCancel Cancel OKLamp Time No Messenger Data appears MY ButtonMode is on, use the / cursor buttons to adjust Active Iris Changes the active iris modePicture Mode Changes the Picture Mode Zoom Turns the D-ZOOM mode on/off. When the D-ZOOMFilter Message ServiceFAN Speed GhostLens Door Close KEY LockLens Door Lock Lens Door Open1NORMAL 2HIGH Remote FreqControl port Parity Serial SettingsBaud Rate Service Communication TypeTransmission Method Response Limit TimeInformation Factory ResetNetwork menu SetupDhcp Subnet DefaultSetup Gateway IP AddressProjector Name AMX D.D MY ImagePresenter QuitPresentation Multi PC Section SwitchingUser Name Guide Security PasswordSecurity menu Enter to the Security menuTurning off the MyScreen Password Turning on the MyScreen PasswordMyScreen If you have forgotten your PIN code PIN LockTurning on the PIN Lock Turning off the PIN LockTurning on the Transition Detector Transition DetectorTurning off the Transition Detector Turning on the MY Text Password MY Text PasswordTurning off the MY Text Password Writing MY TextApplication Presentation toolsInteractive Function System requirementsInteractive Function Connection during use Preliminary preparation Using the penCustomizing the pen Basic pen operationUsing StarBoard Software Supported file format PC-LESS PresentationSupported storage media Supported formatThumbnail menu Selected image Thumbnail images Thumbnail modeEnter Input Setup menu for the selected imageOperating by buttons or keys DownOperating by the menu on the Thumbnail screen PC-LESS Presentation Full Screen Mode Control Projector Software Slideshow modePlay Example of playlist.txt files PlaylistHardware and software requirement for computer USB DisplayUSB Port USB cable 1 piece Floating menu Right-Click menuOptions window Replacing the lamp MaintenanceReplacing the lamp Type number DT01181Lamp warning High Voltage High TemperatureType number UX37191 Filter set Cleaning and replacing the air filterStitched side On next 100 Cleaning and replacing the air filterHitachi MAXELL, part number CR2032 or CR2032H Replacing the internal clock battery101 102 Cleaning clothInside of the projector Caring for the cabinet and remote controlMaintenance of the pen sensors horns Maintenance of the pen104 Other careRelated messages TroubleshootingThere is no input signal An improper signal is inputButton operation is not available Internal temperature is rising106 Regarding the indicator lamps Lens door is not opened properly It is time to clean the air filterThere is a possibility that the interior portion Has become heatedResetting all settings Mode selected for Hdmi Audio is not suitable Signal cables are not correctly connectedVolume is adjusted to an extremely low level Audio SOURCE/SPEAKER setting is not correctFrame Lock function cannot work on the current Input signal Color settings are not correctly adjustedColor Space setting is not suitable Projector is operating in Eco modeSet to Network Bridge Computer cannot start up in the current hardwareSaving function is working Communication Type for the Control port isIs the system started up in the correct sequence? Is the use of USB cables disabled?Is the power of the projector turned on? Is the USB cable connected correctly?Is the volume from the speaker of the projector too loud? This may be due to poor contact of the batteryHas the battery run out? Are you using more than one pen at the same time?Is the projector inclined? StarBoard Software files may be corrupted, orIs the tip of the pen worn out? Is alignment of the pen position correctly performed?Is a part of the image enlarged using the Magnify Function? Is the projector correctly installed?Is the computer image projected within the area Screen? End User License Agreement for the Projector Software Specifications117
Related manuals
Manual 2 pages 39.75 Kb
Top Page Image Contents