Hitachi CP-X935E To turn off the power, Plug&Play, Indicator lights up orange, Standby mode

Page 13

Basic operations (continued)

To turn off the power

3

2

1	1	STANDBY/ON	MUTE
	1
		FREEZE
STANDBY/ON		MAGNIFY VOLUME
		OFF
	INPUT
MUTE		POSITION ON	LASER

MENU

RESET

RESET	RIGHT
MENU ON	MOUSE ON
BLANK	TIMER
RGB	VIDEO
	INPUT

ENGLISH

1		Press the STANDBY/ON button, for 1 second.
		∙ The ON indicator blinks orange and the lamp turns off. (About 1 minute later), the fan stops and
		the indicator lights up orange.
		∙ Press the STANDBY/ON button for short time (less than 1 second), the projector do not set in
		standby mode.

	2	Turn the MAIN POWER switch of the projector off.[ : OFF]

	3	Install the lens cap.

	Caution		∙ To reduce temperature inside the projector, fan will rotate for about 1 minute after the lamp
			is turned off.

∙Do not turn off the MAIN POWER switch during the lamp on because the lamp is damaged.

PLUG&PLAY

This projector complies with VESA DDC1/2B specifications. PLUG&PLAY is a system with computer, peripherals (including projectors), and operating system.

It works when the projector is connected to DDC (Display Data Channel) ready computer that is running an operating system software that incorporates plug & play functionality.

(Only RGB 1)

13

Downloaded from www.Manualslib.com manuals search engine

Image 13

Contents Contents FeaturesOutline Operating GuideFor the Customers in U.K Power cord Video signal cablesBefore use Instructions to UsersDo not install this unit in an unstable place Do not look directly at the lens when Lamp is litDo not use power supplies other Than that specified If any abnormality occursCleaning Be careful in handling the power cordHandle the power cord carefully Do not step on this unit or do not put a Heavy object on itClean inside the unit at least once two years When you are not going to use For a long timeDo not place this unit where it gets hot VolumeNames and functions of each part Contents of shipping boxRGB/VIDEO Disk PAD Remote control transmitterLaser Aperture Names and functions of each partExample of the projector and screen installation InstallationHow to use foot adjusters Basic operations ∙ The on indicator will light up orangeTo project the picture For 3 secondsIndicator lights up orange To turn off the powerStandby mode PLUG&PLAYMagnifying Function Freeze FunctionTo return to the initial setting Adjustments and functionsMemory function ∙ On-screen menus are displayed on the screenHow to use the SET UP menu SET UPManual Operation During AUTO-adjustment Auto-adjustmentInput Auto Confirm ScreenOPT ImageBlank RevealConnection to the RGB signal terminal Connection to the video signal terminalsResolution Standard Display Dots KHz Example of computer signalText Computer/signal Horizontal Timing µs Initial set signalsComputer/signal Vertical Timing lines Horizontal Timing µsControl signal terminal Connection to the control signal terminalADB Mac mouse PS/2 mouseSerial mouse Control command table Control command tableCommunication RS232C cable ReferenceControl data table Auto AdjustVideo System Color BalanceProcedure of setting the Projector status Procedure of getting the Projector statusProcedure of default setting the Projector status Example of command errorConnecting various equipment Example of system setupAC Inlet Computer Note type ComputerDesk typeAir filter Cleaning the air filterRemove the lamp cover How to replace lampLamp Option lamp Lamp unit CP-X935W/E DT00201Action MessageBlink in the following cases Message tableVideo Dimension diagramAudio Batteries LR6