Epson RP-U420 manual TOP HEAD1 HEAD2 HEAD3 HEAD4 HEAD5 HEAD6 HEAD7 HEAD8

		more
C O N F I D E N T I A L	■■ ■■ ■■	more

■If an adjacent dot is specified for the bit image in double-density mode (m = 17), the right side of the adjacent dot is not printed.

■This command is not affected by print modes (double width or underline).

■After finishing processing the bit image, the printer returns to normal data processing mode. The next print starting position is located at the next dot of the last bit-image data.

■"Dot density in the vertical direction" indicates the dot density in the paper feeding direction, and "Dot density in the horizontal direction" indicates the direction perpendicular to the paper feeding direction.

■The bit-image data is developed based on the current print position.

■If the width set for the printing area is less than the minimum width of the bit-image data to be printed, the printer performs buffer full printing for the current print line; then the remaining data is printed from the beginning of the next line.

[Example]	The relationship between the image data and the dots to be printed is as follows:
							Bit image data
		7	6	5	4	3	2	1	0	7	6	5	4	3	2	1	0
	TOP	HEAD1{
		HEAD2{
		HEAD3{
		HEAD4{
		HEAD5{
		HEAD6{
		HEAD7{
		HEAD8{
	Bottom	HEAD9{
		Print data

RP-U420 Bit-image commands ESC ✻ Ver. 1.0 p. 39