Epson RP-U420 manual Ascii DLE DC4

C O N F I D E N T I A L

DLE DC4

■■ ■■ ■■ moremore

EXECUTING COMMAND

[Name]

[Format]

[Range]

[Default]

[Description]

Generate pulse at real-time
ASCII		DLE	DC4	n	m	t
Hex		10	14	n	m	t
Decimal		16	20	n	m	t
n = 1
0	≤ m ≤ 1
1	≤ t ≤ 8

None

Outputs the pulse specified by t to connector pin m as follows:

mFunction

0Drawer kick-out connector pin 2

1Drawer kick-out connector pin 5

	•	The pulse ON time is [t × 100] ms, and the OFF time is [t × 100] ms.
[Notes]	■	The printer executes this command upon receiving this command.
	■	This comand cannot be executed when the unrecoverable error occurs.

■ With a serial interface model, this command is executed even when the printer is offline, the receive buffer is full, or there is an error status.

■ With a parallel interface model, the printer cannot receive data when it is busy; therefore this command cannot be used under the following conditions.

• When DIP Switch 1-6 is On: receive buffer-full.

• When DIP Switch 1-6 is Off: receive buffer-full, offline, error status.

■ This command is executed any time the data sequence <10>H<14>H<n><m> <0> is received, even if it appears as part of another command.

<Example>

In ESC * m nL nH d1 ... dk, d1=<10>H, d2=<14>H, d3=<1>,d4=<0>, d5=<5>

RP-U420 Miscellaneous commands DLE DC4 Ver. 1.0 p. 76