Epson 214D-1 user manual Auto Restart

Page 22

14 Operation

3.2.4Auto Restart

The Batch Controller can be configured to continually repeat the batch process. This mode of operation is selected during the configuration process.

The process is started by pressing the RUN key whereby the normal batch operation is commenced. After reaching the End-of-Batch (see Section 3.2.3), the Batch Controller will then wait for a pre- programmed period before automatically resetting and starting the batch process again.

The STOP key can be pressed at any time to interrupt the batching process and the process can be continued using the RUN key. If, however, the process is to be aborted, the STOP key is pressed again. The Batch Controller is reset and to restart the auto batching process the RUN key is pressed.

HP289

Image 22

Contents

USER’S Manual HP289 HFC Warranty Contents HP289 Introduction Model Number Designation Model 214D- aIntroduction 2A Introduction 2B This page intentionally left blank HP289 Specification GeneralPulse Output Operation Setting the Batch Quantity Front Panel OperationStopping ResettingStarting a Batch Displayed InformationLimit on Batch Size Accumulated TotalBatch Operations Page Control Relays Signal Timeout Flow AlarmEnd-of-Batch Signal End-of-BatchAuto Restart Automatic Overrun Compensation = fxH Calculation of Rate and Total Frequency InputFiltering 103 Total Conversion For ExampleOutput Pulse and Flow Alarm Page RS232/422/485 Interface Option OptionsHardware Multipoint Communication RS422 Interface HP289RS485 Interface HP289 Communication Protocol PrinterComputer Configuration RUNPage Configuring the Setup Parameters BaseStep Display Description Text Entering the Batch Parameters Signal Timeout in seconds Setting to Disables this featureDis EOB Configuring the Options DateEcho Checking the Input Signal Input Circuits Input Circuit for the 214D SeriesSwitch Settings General SpecificationInput Circuits Frequency Input Circuit HP289 Page Page Remote Key Switches Installation GeneralRC Networks for Interference Suppression TerminalDescription Terminal Wiring DesignationsTerminal Relay Option & Switches Terminal RS232/422/485 OptionTrouble Shooting Counting erratically No end of batch, pulse output, or flow alarmInstrument acting erratically Output Errors Error CodesInput Errors Configuration ErrorsIndex Front PanelTerminal Wiring