Epson 214D-1 user manual Entering the Batch Parameters, Dis

Configuration 31

5.2Entering the Batch Parameters

Step	Display	Description	Text
			Ref
1	BATCH	Set Batch Parameters
	OPTION	Options (if installed)	5.3
	TEST	Check Input Signals	5.4
	END	Exit to normal operation
	CAL	Setup Program Parameters	5.1
	The following steps are displayed when BATCH is selected.
2	BATCH L Maximum Batch Size which can be entered.		3.2
	xxxxxx	Set to 0 if no limit on batch size.
3	AUTO S	Automatic restart feature.
	Off	Disable
	On	Enable
	xx:xx	If enabled, automatically restarts the batch	3.2.4
		xx:xx (mins:sec) after the end of the last
		batch.

4START T Slow start time.

xx:xx	Time, in minutes:seconds, when Relay 2	3.2
	will energize once the batch has started.

5PREST Prestop Quantity.

	xxxx	Quantity at which Relay 2 will de-energize	3.2
		before the end of the batch. (e.g., If the
		batch quantity is 100 liters and Prest is 2
		liters, relay 2 will de-energize after 98
		liters.)
6	COUNT	The Batch Total counts Up or Down.
	dn	Count down from the batch quantity.	3.2
	up	Count up from zero.
7	T OUT	The Signal Timeout in seconds (Setting to 00	3.2.2
		disables this feature.).

8AOC Automatic Overrun Compensation.

	Note that the Signal Timeout must be	3.2.5
	greater than 0 (i.e., enabled) for this feature
	to work.
En	Enable.
Dis	Disable.

HP289