Kodak E-PLUS SLIDE Installing the Mechanism Assembly, Replacing the AUTO-FOCUS Bracket Assembly

SERVICE MANUAL

Installing the MECHANISM ASSEMBLY

Important

To insert the SELECT BUTTON into the hole in the SELECT LEVER when installing the MECHANISM ASSEMBLY, hold the SELECT BUTTON completely down.

[1]Do the removal procedure for the MECHANISM ASSEMBLY in reverse order.

Replacing the AUTO-FOCUS BRACKET ASSEMBLY

SCREW SCREW (2)

WORM

PULLEY

AUTO

FOCUSSCREW

CYCLEBRACKET

SOLENOID ASSEMBLY

A091_4023BCA

A091_4023BA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Cut and remove the necessary WIRE TIES.

[4]Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.

[5]Pull the SMALL CIRCUIT BOARD up.

[6]Do the replacement procedure for the MECHANISM ASSEMBLY.

[7]Remove the Torx SCREW (on N.P. models) (or Hex SCREW on Painted Models) from the WORM PULLEY.

[8]Remove the WORM PULLEY.

[9]Remove the 2 Hex SCREWS from the CYCLE SOLENOID.

[10]Remove the CYCLE SOLENOID.

[11]Remove the Phillips SCREW from the AUTO-FOCUS BRACKET ASSEMBLY.

[12]Pull and remove the AUTO-FOCUS BRACKET ASSEMBLY through the hole where the CYCLE SOLENOID was.

Installing the AUTO-FOCUS BRACKET ASSEMBLY

[1]Do the replacement procedure for the AUTO-FOCUS BRACKET ASSEMBLY in reverse order.

14 30APR96 – SM4530-1