Kodak E-PLUS SLIDE, KKE PLUS, J-E PLUS service manual Check that the alignment of the Target

Diagnostics

Malfunction		Check
AUTO FOCUS MOTOR operates continually	1.	Install the TARGET SLIDE TL-3002 in the
		GATE MECHANISM.
	2.	Check that the alignment of the TARGET
		and NULL is correct. If not, see the
		Adjustments section.
	3.	Check for a light leak:
		• Install a different LAMP MODULE
		ASSEMBLY. If the FOCUS MOTOR
		stops operating continually, install a
		new LAMP MODULE ASSEMBLY.
	4.	Check that the voltages across the
		PHOTOCELL are correct. The voltage from
		1 to 2 is 14.5 V ac. The voltage from 2 to 3
		is 14.5 V ac. The voltage from 1 to 3 is 29
		V ac.
	5.	Check that the PHOTOCELL HOUSING
		has 2 FILTERS.
	6.	Install a new PHOTOCELL.
	7.	Check the components on the CIRCUIT
		BOARD for damage.
AUTO FOCUS MOTOR operates continually in	1.	Check that the wires of the AUTO FOCUS
forward only or reverse only and does not		MOTOR are in the correct position; the blue
operate (stops) in the null position.		wire goes to the mark on the AUTO FOCUS
		MOTOR.
AUTO FOCUS adjusts after REMOTE use	1. Do the adjustment for the CLAMP LEVER
		ASSEMBLY.

SM4530-1 – 30APR96 53