Kodak KKE PLUS, J-E PLUS, E-PLUS SLIDE service manual Adjusting the Photocell

Adjustments

Adjusting the PHOTOCELL

PHOTOCELL

CIRCUIT BOARD

wratten FILTER (2)

	POST (2)	PHOTOCELL
		MASK
	PHOTOCELL	A091_4032GCA
	HOUSING
		A091_4032GA
hole	FAN CAP

FAN CAP

light image

A091_4033GCA

A091_4033GA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the removal for the LOWER HOUSING ASSEMBLY.

Important

It is necessary to make a FAN COVER TOOL. See the Tools section.

[3]Install the FAN COVER TOOL over the FAN area and the LAMP MODULE. See the Tools section.

[4]Energize the projector.

[5]Set the projector to the LO-LAMP position.

[6]Install and hold the AUTO FOCUS TARGET SLIDE TL-3002 until it is fully seated in the GATE MECHANISM.

[7]Look through the PROJECTION LENS hole and observe the focus light path on the AUTO-FOCUS TARGET SLIDE TL-3002. Check that the light path is correct. If not, do the adjustment procedure for the FOCUS LIGHT PATH.

[8]Disconnect the main power.

[9]Heat the 2 POSTS on the PHOTOCELL HOUSING to allow the POSTS to bend enough to pull the PHOTOCELL CIRCUIT BOARD up and off the PHOTOCELL HOUSING. Use a

SOLDERING IRON.

[10]Remove the 2 Wratten FILTERS and the

PHOTOCELL MASK.

[11]Install the FAN CAP 232729 in the PHOTOCELL HOUSING.

SM4530-1 – 30APR96 33