Outline — allows you to select the location and size of your electronic image. The preview area will show the outline.
•Origin (x, y):
-if you select Document: Manually Select, (x) is the distance from the left edge of the scanner’s paper path and (y) is the distance from the first portion of the document detected by the scanner.
-if you select Document: Automatically Detect and Straighten
and Image: Part of Document, (x) is the distance from the left edge of the document and (y) is the distance from the top edge of the document.
•Size (w, h): the width and height of the electronic image.
NOTE: The electronic image may be shorter than you specified if the outline goes beyond the end of the scanned document.
•Angle: allows you to select the angle of the outline.
•Predefined sizes: provides a list of commonly used paper sizes. Selecting an item in this list will automatically set the size of the outline to that paper’s size. Custom will be displayed when the outline size does not match any sizes in the list.
NOTE: You can also adjust the outline displayed in the preview area using your mouse.
Border — allows you to select what action to perform on the edges of your electronic image.
•(none)
•Add: includes up to approximately 0.1 inches of border around all of the image edges.
NOTE: This option is not available when both Document: Automatically Detect and Straighten and Image: Part of Document are selected.
•Remove: produces an image that contains just the document by eliminating any residual border. Residual border can be used by variations in a document edge; for example, when a document is not a perfect rectangle and/or was fed crooked.
NOTES:
•While this option will not remove large amounts of residual border, there is a possibility that a small amount of the document will be lost.
•This option is only available when both Document: Automatically Detect and Straighten and Image: Entire Document are selected.
| 51 |