Correcting Problems
7.Repeat the back and forth motion several times to insure that the head is completely clean. Press harder if necessary.
8.Repeat steps 6 and 7 if you have a cleaning pad.
9.Wait for the printhead to dry thoroughly before reloading the ribbon.
CAUTION: Since water is used in this procedure drying time is longer than when using a head cleaning pad. Make sure that you let the printhead dry completely.
10.Reload the ribbon spool once the printhead is completely dry by following the instructions beginning on page 1±17.
11.Close the printer cover.
12.Turn on the printer.
13.Make two test prints on paper.
If you have trouble finding a piece of debris that continues to cause print problems after cleaning, hold one of the streaked prints up to the head to give you a better idea of where the particle is located.
January 1998 | 4±11 |