RESTRICTED USE ONLYFargo Electronics, Inc.
Placing the Printer in the Firmware Upgrade Mode
Step | Procedure | ||
|
|
|
|
1 |
|
|
|
|
|
| Caution: Turn off the Printer and unplug the power cord from the |
|
|
| |
| Printer. | ||
|
| ||
2 | Press and hold down the Power and Pause buttons on the Printer, as shown | ||
| below. | ||
|
| ||
3 | Continue to hold down both the Power and Pause buttons as the power is | ||
| reapplied, hold the buttons down for two (2) seconds after the power has been | ||
| restored and then release. (Note: The LCD display should now show the | ||
| Upgrade Firmware message, as shown below). | ||
|
| ||
4 | Press the Yes button on the LCD to continue with the Firmware Upgrade. | ||
|
|
|
|
DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3) | 19 |