FARGO electronic DTC300M, DTC400 manual Downloading Firmware continued, Step, Procedure

Page 7
Procedure

RESTRICTED USE ONLYFargo Electronics, Inc.

Downloading Firmware (continued)

Step

Procedure

 

 

 

3

a.

Check that the Computer has an active internet connection.

 

b.

Click on the Yes button, as shown below.

 

 

 

DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3)

7

Image 7
Contents DTC400/DTC300/DTC300M Card Printer/Encoders - Firmware Upgrade Document RevPart Number L000575 Revision Firmware Upgrade Instructions Table of ContentsIntroduction RequirementsSafety Messages review carefully Click on the Start icon on the desktop Downloading FirmwareClick on the Diagnostic Utility, as shown below ProcedureStep Procedure Downloading Firmware continuedClick on the Yes button, as shown below ProcedureClick on the Go button, as shown below Using the drop down menu select the PrinterThis will launch the Fargo Support page Click on the Firmware selection boxRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc ProcedureDownloading Firmware continued StepRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Click on the .frm file Select the Desktop dropdown menuClick on the Open button, as shown below Placing the Printer in the Firmware Upgrade Mode Upgrade Firmware Send File Now Sending the Firmware File 4The procedure is now completed Sending the Firmware File continued