FARGO electronic DTC300 Downloading Firmware, Click on the Start icon on the desktop, Procedure

Page 5

Downloading Firmware

RESTRICTED USE ONLY

Fargo Electronics, Inc.

Downloading Firmware

Step

Procedure

1Open the Fargo Diagnostic Utility (located in the Programs folder), as shown below.

•Click on the Start icon on the desktop.

•Select the Programs folder.

•Select the Fargo folder.

•Click on the Diagnostic Utility, as shown below.

DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3)

5

Image 5

Contents Part Number L000575 Printer/Encoders - Firmware Upgrade Document RevDTC400/DTC300/DTC300M Card Revision Introduction Table of ContentsRequirements Firmware Upgrade InstructionsSafety Messages review carefully Click on the Diagnostic Utility, as shown below Downloading FirmwareProcedure Click on the Start icon on the desktopStep Procedure Downloading Firmware continuedClick on the Yes button, as shown below ProcedureThis will launch the Fargo Support page Using the drop down menu select the PrinterClick on the Firmware selection box Click on the Go button, as shown belowRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedDownloading Firmware continued ProcedureStep RESTRICTED USE ONLYFargo Electronics, IncRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Downloading Firmware continuedRESTRICTED USE ONLYFargo Electronics, Inc Click on the Open button, as shown below Select the Desktop dropdown menuClick on the .frm file Placing the Printer in the Firmware Upgrade Mode Upgrade Firmware Send File Now Sending the Firmware File 4The procedure is now completed Sending the Firmware File continued